is essential to complete the structure to the satisfaction of the building owner This manual has been prepared to help guide the installation process and reflects the techniques in use in the metal building industry believed to be most representative of good installation practices These pro-cedures and methods are by necessity general in nature
5 1 4 1 Dead Load: This is the actual self-weight of the metal building The metal building manufacturer will calculate this 5 1 4 1 1 Do not specify a “dead load” or confuse it with the collateral load discussed above [Code reference: Section 1606 1] 5 1 4 1 2 Designers are cautioned that metal building self-weight dead loads are
Metal roofing panels are slippery when wet, dusty, frosty, or oily -- Do Not attempt to walk on a metal roof under these conditions Wear soft-soled shoes to improve traction and to minimize damage to the paint finish Always be aware of your position on the roof relative to any roof openings, roof edges, co-workers, and penetrations
3/17 American Building Supply, Inc 3 Finish Chart ANSI/MHMS Code US Code Finish Description Base Material Common Names 600 USP Primed for painting Steel 601 US1B Bright black japanned Steel 603 US2G Zinc plated Steel 604 Zinc plated and dichromate sealed Steel 605 US3 Bright brass, clear coated Brass Polished Brass
www midwestmanufacturing com Available at Perforated Liner Panel Dura-Panel Liner Panel Pro-Rib Liner Panel Galvanized SKU# 155-8080 White SKU# 155-8085 White SKU# 155-8182
4 October 2021 • ASC Building Products www ascbp com Roof Preparation ASC Building Products Metal Roofing can be used in both new construction and retrofit roofing applications We recommend the installation of metal roofing over a continuous rigid substrate such as plywood/OSB, or over spaced supports Contact ASC
Before the Mueller prefabricated steel building arrives, the site and foundation should be of the panels over an extended period can severely attack the finish and reduce the effective purlins, vapor barrier to the inside of the building
Fiber glass insulation for metal buildings is called NAIMA of heat, keeping it inside the building in winter and pleasing interior building finish and should be
polyurethane foam (SPF) may be applied to metal building exteriors or interiors inside air Insulation thickness to control this condensation must be based on the design dew point and the greater thickness to achieve a suitable finished
Metal buildings usually require trim or GUTTERS along the eaves the end walls and side walls meet is typically finished out with quired interior supports