[PDF] configuration pat cisco

Lab 1.1.5 Verifying NAT and PAT Configuration

Configure a router for Network Address Translation (NAT) and Port Address Translation (PAT). • Test the configuration and verify NAT/PAT statistics.

Configure Port Address Translation (PAT) on RV320 and RV325

The objective of this document is to show you how to configure port address translation on the RV32x Series VPN Routers.

PPTP Port Address Translation

layer gateway (ALG) for Port Address Translation (PAT) configuration. How to Configure PPTP Port Address Translation on page 2.

User Defined Source Port Ranges for PAT - Cisco

Even port parity for SIP H.323

Lab – Configuring Port Address Translation (PAT)

This document is Cisco Public. Page 1 of 6. Lab – Configuring Port Address Translation (PAT). Topology. Addressing Table. Device. Interface. IP Address.

PPTP Port Address Translation

The PPTP ALG is enabled by default when Network Address Translation (NAT) is configured. This module provides information about how to configure the PPTP ALG 

Lab 1.1.6 Troubleshooting NAT and PAT

Configure a router for Network Address Translation (NAT) and Port Address problems occur during this configuration refer to Lab 1.1.4a Configuring NAT.

IP Addressing: NAT Configuration Guide Cisco IOS XE 17

Configuring Dynamic Translation of Inside Source Addresses 16. Configuring the Same Global Address for Static NAT and PAT 18.

Provisioning NAT/PAT Support

This chapter describes the steps required to configure the Hosted UCS platform when a Cisco NAT/PAT router or firewall connects the IP phones and the VOSS 

Configuring PPTP Through PAT to a Microsoft PPTP Server

19 Oct 2006 For more information refer to the NAT ? Support for PPTP in an Overload (Port Address Translation). Configuration section in the Cisco IOS ...

What is dynamic Pat on Cisco ASA?

... This document provides a sample configuration for dynamic PAT on a Cisco Adaptive Security Appliance (ASA) that runs software version 8.3 (1). Dynamic PAT translates multiple real addresses to a single mapped IP address by translating the real source address and source port to the mapped address and unique mapped port.

How do I Test PAT configuration?

Testing PAT Configuration In this lab we configured PAT on R1for 10.0.0.10 and 10.0.0.20 and static NAT on R2 for 192.168.1.10. Device Inside Local IP Address Inside Global IP Address Laptop0 10.0.0.10 50.0.0.1 Laptop1 10.0.0.20 50.0.0.2 Server 192.168.1.10 200.0.0.10 To test this setup click Laptop0and Desktopand click Command Prompt.

How do I configure Pat/Nat correctly the first time?

To configure PAT/NAT correctly the first time, you need to understand the Cisco NAT terminology and how your IP networks/addresses map to each of the entities listed below: Inside Local—This is the local IP address of a private host on your network (e.g., a workstation's IP address).

How many local addresses does Cisco IOS Pat support?

This prevents end stations from seeing connection requests with source ports apparently corresponding to the Telnet, HTTP, or FTP daemon, for example. As a result, Cisco IOS PAT supports about 4000 local addresses that can be mapped to the same global address.