[PDF] minipage latex figure

latex minipage fig - MIT CSAIL

\begin{figure} \begin{minipage}{5 8cm} \begin{tabular}{c} \includegraphics[height=4 8cm]{totalPPFLeoTrueCSFx3_136 eps} \\ (a) \end{tabular} \end{minipage}

The subfigure Package

\begin{minipage}{1 2in} figure code \end{minipage} \caption{Here are two figures side-by-side } \label{fig:1figs} \end{figure} Further, if you place the caption inside the \parboxor minipage, then the width of the caption will be limited to the width of the parbox or minipage as shown in figures 2 and 3: \begin{figure} \centering

The sub gure Package - Brown University

\begin{minipage}{1 2in} figure code \end{minipage} \caption{Here are two figures side-by-side } \label{fig:1figs} \end{figure} Further, if you place the caption inside the \parboxor minipage, then the width of the caption will be limited to the width of the parbox or minipage as shown in gures 2 and 3: \begin{figure} \centering

The subcaption package

The subfigure & subtable environments are just simple minipage environments with \setcaptionsubtype as first contents line These environments are defined with the help

NotesTeX - University of Washington

Since the fullpage environment uses a minipage, and minipages do not workovermultiplepages,onewillneedanewfullpage perpage Remark Also, please note marginnote, or sidenotes cannot be used in this environment Footnotes,ontheotherhand,canbeusedbutarereallyugly

Research 101 Paper Writing with LaTeX

•Use one tex file for each figure, table, and algorithm •Leave the main texwith only main texts •Help focus on finetuning each figure •Avoid copying and pasting an entire block of tables/figures •Use \input{FILE_NAME} to include the file to the main paper •\input{figures/teaser} •\input{figures/overview}

The subcaption package - ibiblio

For the environments figure & table, and all the ones defined with \Declare- FloatingEnvironment offered by the newfloat package, this will be done automati- cally, but for other environments (e g the ones defined with ewfloat offered by the

A package for rotated objects in LaTeX

The sidenotes package - CTAN

figure* The figure* environment is used to position gures across the full page, i e the text width plus the margin The algorithm has to distinguish between recto and verso (left and right) pages and might need up to three LATEX runs to provide table* the desired result The corresponding caption style is called wide gure The sister

The epigraph package - The CTAN archive

The htextiargument is put into a minipage of width \epigraphwidth If you use something other than \epigraph or epigraphs for the htextiargument, you may have to so some positioning of the text yourself so that it is properly located in the minipage For example \chapter{Short} \renewcommand{\epigraphflush}{center} \epigraphhead{\centerline