To NICE FLOX2R Receiver. Press and release the Yellow Learn Button on the receiver inside the Apollo Box (see Figure 1). The Red LED Indicator next to the
This receiver is part of the “Flor” series by Nice spa. This series of receivers is intended for use on the Control units featured in automated systems for
Before you pair the keypad with your Nice Apollo receiver you will need to program your codes. 1. Enter master code 1251 into the keypad. 2. You will hear a
Nice contact information is at the bottom of this page and on the last page of this installation manual. There are four kits available using the Mercury 310
Nice Apollo 1050. Control Board. Vehicular Gate Control Board www.ApolloGateOpeners.com
installation and programming of the Apollo 1050 gate controller for a Nice-brand receiver which can be controlled by up to 1000 transmitters. A.
2): terminal 1 = sheath; terminal 2 = core. – Aerial connection for models with Nice connector: connect the aerial cable to the purpose-provided terminals on
Set relay output time on 951N to 5 seconds by pressing: Master Code (3 beeps) 5# (3 beeps) 5#. 2. Put the 318N receiver into programming mode by pressing
But for a typical NICE FLOX2R Receiver the programming procedure is as follows: 1. Press the learning button on your receiver for 1-2 seconds. The LED will
??? ?????????? ????????? ????????????? ????? ????? Nice ?????????? ????????????????. SMXI
This receiver is part of the “Flor” series by Nice spa This series of receivers is intended for use on the Control units featured in automated systems for gates garage doors and road barriers Any other use is to be considered incorrect and forbidden! The manufacturer shall not be held liable for damage due to improper use of the product
FLOXIR FLOXI2R AERIAL 2ND RELAY OUTPUT 1ST RELAY OUTPUT POWER: from 20 to 28 V direct or alternate normally supplied by the unit 1" RELAYOUTPUT: free contact of a normally open relay used for unit command 2"d RELAY OUTPUT: free contact of a normally open relay available on specific unit terminals (oniy on 2-channel receivers) AERIAL:
FLOx2R Receiver Connection Bx1K Bx2K FLOx1 FLOx2 ApolloGateOpeners com (800) 878-7829 Force- Slowdown- AutoClose- Jump" Nice Modal 936 GRO— 2av— COM— Fuse Battery — Main Fuse Nice 0 0K Open — Stop— Close— Safety Nice IJL325 Compliant Monltorøa satery aev1cetsJ Antenna
A Before you pair the keypad with your Nice Apollo receiver you will need to program your codes 1 Enter master code 1251 into the keypad 2 You will hear a beep 3 Press the number one (1) key and the keypad will beep again 4 Enter the personal 4-digit code you want to use to open your gate 5 You will hear two short beeps 6
%20VERY.pdf