switch on the front of the controller in the. Auto position. Step 5. Turn on the Main. Power Switch and follow the instructions on the. Teach Pendant to.
show a basic knowledge about FANUC robots controllers and Teach Pendant by basic course for robot operators
Teach Modes (T1 etc). ?. Must be in this mode to develop a program using the teach pendent. ?. Top robot movement speed is limited.
Except the robot the robot controller and the robot teach pendant depend on the system
Robot. • Robot controller. • Teach pendant. • Safety fence. • Interlocked gate. • Interlocking device. • End effector. • Other peripheral equipment. •
FANUC Robotics manuals present descriptions specifications
(Teach pendant enable switch must be OFF and Auto/T1/T2 switch must be in 'Auto' position) the basic camera setup should already have been done by FANUC.
You can check Controller ID by the teach pendant connected to the robot controller or the all backup of the robot controller. 1. Press the MENU key and select “
Such systems consist of robots extended axes
Review of the Teach Pendant options possibilities