Installation and O peration M #8 x ?" Sheet Metal Screws. Quantity ... 10001 Reunion Place San Antonio
©2020 Electrolux Home Products Inc Instruction Sheet A00343903 09 01 20 Created Date: 20201008183745Z
• Install Setup Quick Check • Preventative Alerts & Guidance • Performace & Usage Reports Title: Spec Sheet Created Date: 3/14/2022 5:10:48 PM
Gas appliance and connector installation MUST conform with all local codes and regulations including municipal and state building codes and to all local utility regulations In the absence of local code the installation must conform with the National Fuel Gas Code ANSI Z223 1/ NFPA No 54 Uniform Plumbing Code or International Fuel Gas Code
BEFORE YOU START TO INSTALL YOUR UNIT SAVE THIS MANUAL Incorrect installation may create condition where the operation of the product could cause personal injury or property damage The furnace shall be installed so the electri-cal components are protected from water This product must be installed in strict compliance with the enclosed
Use sheet metal screws to secure the fastening strap to the top surface of the AQUECOIL and then to the side of the Air Handler INSTALLATION Before starting the installation of the AQUECOIL into the air distribution system verify that the System Air Handler has been properly and completely installed Since the AQUECOIL is
WARNING: Install the restraining cable parallel to the gas appliance connector Step 1: Drill out a hole in the wall and install the metal claw anchor by using a washer against the wall Step 2: Drill out a hole in the appliance and install the eye bolt with a washer through the hole
NOTE: Do not install the power cord without a strain relief The strain relief bracket MUST be installed before reinstalling the rear range wiring cover D For 3/4” conduit installations only purchase a squeeze connector matching the diameter of your conduit and assemble it in the hole Insert the conduit through the squeeze connector and
Wire connections are made by stripping approximately 1?4-inch of insulation from the end of the feed wire inserting it into the proper base terminal and tightening the screw to secure the wire in place Do not put wires more than 2 gauge apart under the same clamping plate TWO-WIRE COMPATIBILITY
Installation Instructions Place the top bracket on the top of the microwave oven with the tabs on the top and sides of the bracket fitting squarely against the microwave oven Drill pilot holes through the holes in the top bracket Attach the top bracket to the cabinet using nine round-head screws
install this equipment Failure to follow safety recommendations could result in possible damage to the equipment serious personal injury or death • The installer must comply with all local codes and regulations which govern the installation of this type of equipment Local codes and regulations take precedence
Install mounting bracket 1 Level the bracket 2 Mark two drilling spots Use either the inner or outer pair of holes If necessary you can use the additional holes to secure the bracket 3 Drill holes in the installation surface 4 Install the mounting bracket and secure with screws When selecting the installation location: