router-config located on the flash memory card inserted in the second Personal Computer Memory Card. Industry Association (PCMCIA) slot of the Route Switch ...
This command is available only on specific router platforms connected to a Catalyst 5000 switch. Use this command to reduce multicast load on the router.
This chapter provides procedures for configuring the basic parameters of your Cisco router including global parameter settings
Exits configuration mode for the GE interface and returns to global configuration mode. Page 4. 8. Cisco 800M Series Integrated Services Routers Software
router at. 209.165.202.3: nfvis(config-switch)# ip route 209.165.201.2 255.255 ... To enable IP routing use the ip routing command in switch configuration mode.
“Command Line Interfaces” in the Catalyst 6500 Series Switch Cisco IOS Software Configuration everything inside the router
The physical Layer 3 interfaces allow the. Catalyst 4500 series switch to be configured like a traditional router. Page 2. 23-2. Software Configuration Guide—
Cisco IOS commands and the switch software features. Before using this guide you should have experience working with the concepts and terminology of ...
For details about this command and additional parameters that can be set see the Cisco IOS · Switching Services Command Reference. Step 3 exit. Example: Router
In Cisco IOS documentation the term router may be used to refer to various Cisco products; for example
switching features were presented in the Cisco IOS IP Switching Command (Optional) When the router or switch is transmitting translates Per-VLAN.
Cisco Router Basic Configuration Reference. Basic Global Configuration. Command example. Description enable. Enter Privileged Exec mode configure terminal.
This chapter provides procedures for configuring the basic parameters of your Cisco router including global parameter settings
Catalyst 2960 Switch Cisco IOS Commands 2-1 aaa accounting dot1x 2-1 Identify this port as connected to a trusted switch or router and automatically.
Feb 29 2008 Cisco IOS IP Routing: Protocol-Independent Command Reference ... Cisco IOS Multiprotocol Label Switching Command Reference.
The physical Layer 3 interfaces allow the. Catalyst 4500 series switch to be configured like a traditional router. Page 2. 23-2. Software Configuration Guide—
Catalyst 4500 Series Switch Cisco IOS Command Reference. Copyright © 2011 Cisco Systems no ip routing command and specify ip routing to reenable it.
Cisco 800M Series Integrated Services Routers Software Configuration Guide. Chapter Basic Router Configuration. Configuring Gigabit Ethernet WAN Interfaces.
Note: If your router is running a version of Cisco IOS prior to releases 12.2(14)S Catalyst 4500 Series Switch IOS NetFlow Configuration Guide.