Cisco NX-OS cannot act as a stratum 1 server. You cannot connect to a radio or atomic clock. We recommend that the time service that you use for your network is
The Cisco NX-OS device can use NTP to distribute time. Other devices can configure it as a time server. You can also configure the device to act as an
Set the time zone for synchronization with the NTP server. See Configuring the System Clock. • Perform the steps to provision NTP on the Cisco ME 1200 NID . See
The Cisco NX-OS device can use NTP to distribute time. Other devices can configure it as a time server. You can also configure the device to act as an
Dec 6 2012 You must enable the time server that transmits NTP broadcast packets on the interface of the given device by using the ntp broadcast command ...
Cisco ME 1200 Series Carrier Ethernet Access Devices UCS Controller Configuration Guide Set the time zone for synchronization with the NTP server.
This chapter describes how to configure the Network Time Protocol (NTP) on the NTP synchronizes timekeeping among a set of distributed time servers and ...
When you enable and synchronize the system time clock using an NTP server you must reboot the Cisco. Enterprise NFVIS so that the BMC or CIMC date and time
This chapter describes how to configure the Network Time Protocol (NTP) on Cisco MDS 9000 Series switches. • Information About NTP on page 1. • Prerequisites
Cisco Nexus 5000 Series NX-OS System Management Configuration Guide Release 5.0(3)N1(1) -Configuring Other devices can configure it as a time server.