Instructions for Miniflam AP Piezo Ignition Torch. The miniflam “AP” Blue Head can be characterized by a very sharp flame that can be adjusted in.
Instructions for Miniflam BP Piezo Ignition Torch. The miniflam “BP” Green Head can be characterized by a very sharp flame that can be adjusted in.
miniflam. GP. ¨ CHALUMEAU MULTIPLES USAGES. FLAMME REGLABLE 1600°C. MULTI-PURPOSE TORCH Piezo ignition: air is needed for proper ignition
Miniflam torch heads - Miniflam Schweissköpfe - Cabezas Miniflam piezo. Il se recharge comme un briquet avec les cartouches de gaz Miniflam.
plete with fastening lugs gong
Instructions: Sandblast the surface to be faced with min. Natural Shade: Lighter Pink Shade ... MFMG Miniflam Butane Torch Refill Gas 300g
Rechargeable torch piezo ignition - Adjustable flamme 1600°C Se recharge comme un briquet avec une cartouche de gaz miniflam® CH211.
Parinaud hand-help chart Reloads like a lighter with a gas cartridge "MINIFLAM” CH211 ... CH 210 Rechargeable welding torch with Piezo ignition head.
Rechargeable torch Piezo ignition head - Adjus- Se recharge comme un briquet avec une cartouche de gaz miniflam® CH211. ... Parinaud hand-help chart.
Instructions for Miniflam AP Piezo Ignition Torch The miniflam “AP” Blue Head can be characterized by a very sharp flame that can be adjusted in length from 1/4” to 1/2” by adjusting the gas flow APERTURE: For proper ignition apertures on the AIR regulator band must be 3/4 opened
Instructions for Miniflam BP Piezo Ignition Torch The miniflam “BP” Green Head can be characterized by a very sharp flame that can be adjusted in length from 1/2” to 1” by adjusting the gas flow Screw on Gas Source until hand tight It is normal that a little gas escapes during this procedure
BLAZER® gas torch has been adjusted for perfect functioning Do not make technical changes When refilling keep away from open flame or sparks Please make sure after using BLAZER® gas torch that the gas flow control knob is firmly closed and the flame completely extinguished
Instructions: To Fill Gas Tank: Turn unit upside down and firmly push the butane can nozzle into the filling valve (Fig D) The tank should be filled in approximately 15 seconds Please allow a few minutes after filling for the gas to stabilise To Ignite Torch: • Make certain that hands free lever (C) is positioned in the down position
SYMPTOM ACTION 1 Intermittent ignition or no ignition spark STEP 1Remove burner tip press button G to see if there is a spark if no spark is seen remove part A and check for spark if there is a bright spark clean out Burn tube A to ensure there is no solder or flux causing an obstruction and put original burn tube back and see if the torch in
To trouble shoot a piezo igniter you will need a good pair of insulated pliers (figure 2) and any tools that are needed to remove the igniter from the unit Shut off any gas supply to the unit and remove the piezo igniter Check the igniter for any visible cracks or breaks