1) Screw center stem onto threaded pipe on top of fixture body. 2) TURN OFF POWER. IMPORTANT: Before you start NEVER attempt any work without.
1) Screw center column onto coupling at top of fixture body. 2) Turn oFF Power. IMPORTANT: Before you start neVer attempt any work without.
13) Placer le cache au plafond. 14) Fixer le cache en serrant la bague filetée sur le collierécrou. 15) Visser l'extrémité tube fileté avec le talon l déjà
1) Turn off power. IMPORTANT: Before you start neVer attempt any work without shutting off the electricity until the work is done. a) Go to the main fuse
1) Turn off power. 2) Slip fixture over post and mark position of mounting holes in post. 3) Remove fixture from post. 4) Drill 3/16” dia holes in post at
10) Assemble stem to fixture -. 11) Note direction of exposed threaded pipe on illustration. Bottom two pipes will have exposed thread at top.
If the fixture to be replaced has a switch or pull chain place those in the “off” position. 2) find the appropriate threaded holes on mounting strap. Assemble.
1) Pass wire from fixture though stem and screw stem to top of fixture. NOTE: Thread locking compound must be applied to all stem threads.
1) Screw center stem to top of fixture body. 2) Pass wire through stem and screw stem to top of center stem. NOTE: Thread locking compound must be applied
11) Placer le cache au plafond. 12) Fixer le cache en serrant la bague filetée sur le collier-écrou. 13) Soulever l'abat-jour jusqu'au luminaire en passant
your cooktop’s assembly instructions for help Install the extractor hood The extractor hoods from IKEA can be installed in two ways: either vented to the outside called extraction or used in recirculation mode fitted with a charcoal filter Each installation option is described in the assembly instructions that come with the product
INSTALLATION INSTRUCTIONS Pass fixture wire from coupling[K] on top of main body through desired number of short threaded tubes[A] and stems[B] Screw stems together using short threaded tubes Thread assembled stems into coupling[K] on top of main body
Assemble fixture as shown in illustration above Be sure to run wire leads through slot in stake Lay the fixtures out where you want to locate them The first fixture should be at least 10 wire feet from the power pack WARNING-RISK OF ELECTRICAL SHOCK: Do not place a xture within 10 feet of a poolor spa
3 Never use light bulbs with wattage ratings that exceed the fixtures maximum rating Always make sure the electric current is turned off before changing the bulbs 4 If you experience difficulties installing the lighting fixture or it fails to work as expected please contact a local qualified licensed electrical contractor 5
Nov 18 2011 · This instruction sheet covers the installation of the following Kichler® Transformers: 15PR100SS 15PR200SS 15PR300SS 15PR600SS 15PR900SS Read these instructions carefully before installing this unit This power supply is for use with landscape lighting systems only
iNSTAllATiON iNSTrUcTiONS P/N: 12353BK 12353Wh NOTe: All installations should comply with national and local electrical codes if you have any doubts concerning installation contact a qualified licensed electrician iMPOrTANT SAFeTY iNSTrUcTiONS A) Read all instructions B) Do not conceal or extend exposed conductors through a building wall