Ce document décrit la configuration d'un routeur Cisco IOS pour connecter un réseau à Internet avec la traduction d'adresses de réseau (NAT) via deux
NAT fonctionne sur un routeur Cisco qui connecte deux réseaux ensemble et traduit les adresses privées (locale interne) dans le réseau interne aux adresses
La fonctionnalité NAT permet de translater une adresse IP local en adresse IP publique. Idum. 14 avril 2015 -- N.Salmon -- article_278.pdf. Idum > Réseau >
EXEMPLE de CONFIGURATION du NAT sur ROUTEUR CISCO. Configuration du NAT. On peut : Routeur(config)# ip nat inside source static 192.168.0.1 200.100.40.1.
Cet exemple de configuration fonctionne pour un très petit bureau qui se configurer un routeur à deux interfaces avec NAT à l'aide d'un pare-feu Cisco ...
Ce document explique comment configurer le routeur Cisco IOS dans un VPN Choisissez le Configure > NAT > Edit NAT Configuration et cliquez sur les ...
Cela inclut la configuration de l'adresse IP du routage par défaut
Dans certaines situations vous aurez sûrement à configurer les commandes de traduction des adresses réseaux (NAT) statique et dynamique sur un routeur Cisco.
10 oct. 2010 Page 2/8. Router(config)#ip nat inside source list 1 pool public-access. Configuration de la translation d'adresse statique NAT.
Référez-vous à Routeur à trois interfaces sans configuration de pare-feu Cisco IOS NAT afin de configurer un routeur à trois interfaces sans NAT à l'aide du
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide OL-5332-01 Chapter 1 Basic Router Configuration Configuring Basic Parameters Configure Fast Ethernet LAN Interfaces The Fast Ethernet LAN interfaces on your router are automatically configured as part of the default
ii Cisco Router Configuration Handbook Cisco Router Configuration Handbook Second Edition Dave Hucaby Steve McQuerry Andrew Whitaker Copyright © 2010 Cisco Systems Inc Published by: Cisco Press 800 East 96th Street Indianapolis IN 46240 USA All rights reserved No part of this book may be reproduced or transmitted in any form or by
When configuring Dynamic NAT the inside and outside interfaces must first be identified: Router(config)#int e0/0 Router(config-if)#ip nat inside Router(config)#int s0/0 Router(config-if)#ip nat outside Next a pool of global addresses must be specified
1. Allow Internal Users to Access the Internet 2. Allow the Internet to Access Internal Devices 3. Redirect TCP Traffic to Another TCP Port or Address 4. Use NAT For a Network Transition 5. Use NAT for Networks that Overlap This document describes how to configure the Network Address Translation (NAT) on a Cisco router.
First, we have to assign Fa0/0 as NAT inside interface and Fa0/1 as NAT outside interface on R1. This would tell the router that interesting traffic entering or exiting these two interfaces will be subject to address translation. Enter configuration commands, one per line. End with CNTL/Z.
There are a couple of very useful Cisco IOS commands that can be used to do just that. Command show ip nat statistics displays the number of static and dynamic NAT translations, inside and outside interfaces, and the number of hits and misses. Command show ip nat translations displays the IP addresses for NAT translations.
Network Address Translation (NAT). NAT allows a host configured with a private address to be stamped with a public address, thus allowing that host to communicate across the Internet. It is also possible to translate multiple privately-addressed hosts to a single public address, which conserves the public address space.