25 Mar 2014 Cloud CX263 Jumper Settings. Ref. Description. Default Location. Notes. J1. Mic 1 phantom power. OFF. Rear right: Lower PCB.
Please review these jumper settings prior to installing your new hard drive into your computer. You may want to review more detailed information about the
Please review these jumper settings prior to installing your new hard drive into your computer. You may want to review more detailed information about the
Use double header pins on this module. All four jumers to right hand setting. Top 3 jumpers set start address to 0x0000. Bottom jumper sets lower 32k to be
25 Mar 2014 Cloud CX261 Jumper Settings. Ref. Description. Default Location. Notes. J1. Mic 1 phantom power. OFF. Rear right: Lower PCB.
Using the jumper pins you can establish the drive Master/Slave configuration. Fireball ST. Jumper Settings. Page 2. Fireball ST.
SCSI Jumper Settings. 1 of 1. Configuration Guide. Jumper Settings. Set SCSI ID Note: LPS SCSI does not use a jumper to determine termination.
Please review these jumper settings prior to installing your new hard drive into your computer. You may want to review more detailed information about the
25 Mar 2014 Cloud 46-50 Jumper Settings. Ref Description. Default Location. Notes. J1. Mic1 Phantom. OFF. Rear right: Lower PCB. J2. Mic2 Phantom.
Use this jumper setting only if the drive does not work as a master with no jumpers installed. Figure 1. Master/slave jumper settings.