Compatible DownVision transducer; transom or through-hull mount. Refer to 3.5 Compatible transducers for a list of compatible products. • Compatible Raymarine
An innovative transducer tube housing design allows the CPT-S In-Hull to mount in hulls ranging from 0 to 25 degrees deadrise. www.raymarine.com. SIMPLE TO
Raymarine P58 Transom Mount Transducer e7D Fishfinder when using the transducer adapter cable ... Compatible hull material: aluminum and fiberglass.
Check the website www.raymarine.com for the latest software releases for your product. 3.5 DownVision™ transducer compatibility on page 22.
25 sept. 2018 PDF format from the website: www.raymarine.com/manuals. ... Transducer installation instructions . ... 3.5 Compatible transducers .
3 avr. 2017 website for compatible transducers: www.raymarine.com/transducers. RV–100 RealVision™ 3D Transom Mount Transducer. Part number. Description.
compatible Garmin chartplotter1. Available with trolling motor transom and thru-hull mount transducer options. Current LiveScope System customers can
Transducer Compatibility Matrix for Furuno Sounders www.FurunoUSA.co Transducer. Housing ... Compatible (Connectable) / –: Not compatible. AF: ACCU-FISH.
27 jui. 2019 PDF format from the website: www.raymarine.com/manuals. ... 2.4 Compatible transducers - Element HV displays.
3 avr. 2017 website for compatible transducers: www.raymarine.com/transducers. RV–100 RealVision™ 3D Transom Mount Transducer. Part number. Description.
An innovative transducer tube housing design allows the CPT-S In-Hull to mount in hulls ranging from 0 to 25 degrees deadrise www raymarine com SIMPLE TO INSTALL The CPT-S In-hull is designed for glue-in installation on vessels with non-cored fiberglass hulls
Transducer can be removed from bracket without the use of tools for easy service and storage Boat Size: Up to 12 m (40’) www airmar com P66 Technical Information Due to the wide beams of the P48W and TM270W they have been omitted from the table SPECIFICATIONS Weight: 0 5 kg (1 1 lb) Hull Deadrise: 30° Acoustic Window: Layered plastic urethane
transducer housing (Figure 6) 2 The paddlewheel assembly is a loose slip fit Carefully slide the speed sensor upward while keeping the paddlewheel assembly inside (Figure 7) 3 Insert a blade screwdriver between the cover and the transducer housing (Figure 8) Pry each side apart in turn 4 Lift the cover up and off 3 38mm (1-1/2") slope
The transducer beam must be unobstructed by the keel or propeller shaft(s) Choose a location away from interference caused by power and radiation sources such as: the propeller(s) and shaft(s) other machinery other echosounders and other cables The lower the noise level the higher the echosounder gain setting that can be used
Attach the transducer to the surface bracket and hold in the desired position Use a pencil to mark pilot holes through the mounting holes on the surface bracket 4 Drill the pilot holes 5 Apply a marine high-grade above- or below-waterline sealant/ adhesive compound to the pilot holes 6 Align the transducer mounting holes over the pilot