With your radio turned off connect your radio to your computer using the Baofeng UV-5R Programming cable. 3. Start CHIRP. 4. Turn on your radio and wait for
Any use of a radio must be in accordance with airline regulations or crew instructions. Turn off your radio before entering a blasting area. . For vehicles with
? This equipment shall be serviced by qualified technicians only. ? Do not modify the radio for any reason. ? Use only BAOFENG supplied or approved batteries
Contributions taken from: “Baofeng UV-5R User's Guide” by The Radio Frequency (VFO) mode is also used for programming channels into memory.
Contributions taken from: “Baofeng UV-5R User's Guide” by The Radio Frequency (VFO) mode is also used for programming channels into memory.
Any use of a radio must be in accordance with airline regulations or crew instructions. • Turn off your radio before entering a blasting area. • For vehicles
Consider this the basic manual that should have come in the box. A Note on CHIRP Software. If you've done any bit of research into getting your UV-5R up and
Website: http://baofengtech.com. FC. BTECH. VHF & UHF TRI BAND FM TRANSCEIVER. UV-50X3 SERIES. OPERATING MANUAL. LOCK. FUD 137.000 479.975.
Press the PTT “+” button and Power button at the same time and hold for 3 to 5 seconds until you hear a “chirp” sound and the voice prompt “Programming Mode”.
Contributions taken from: “BaoFeng UV-5R User's Guide” by The Radio Frequency (VFO) mode is also used for programming channels into memory.