Build: Install the closet system to fit your needs now more than 48-inches
Do not make cuts where vertical spacers are on front lip of shelf. a. Place shelf caps onto exposed Place closet rod into closet rod supports as shown.
standards for easy installation of wood or wire shelves and all accessories. • Heavy-duty steel construction. • Accommodates closet pole hook. • Bracket cap
Never place closet rod supports more than 3 ft. apart. b. Place closet rod caps onto Do not make cuts where vertical spacers are on front lip of shelf.
Make sure to distribute the weight evenly on each shelf and use the Closet rod support bracket a maximum of 36 in. spacing.
Make sure to distribute the weight evenly on each shelf and use the Closet rod support bracket a maximum of 24 in. spacing.
Make sure to distribute the weight evenly on each shelf and use the Closet rod support bracket a maximum of 36 in. spacing.
Shelf & Rod shelving. Always use 12 in. brackets for this type of shelving. When installing 16 in. SuperSlide® with Closet Rod & Support always use 12 in.
Adjustable closet rods with attached plastic flanges make wall installations quick and easy and can be used for wall mounting or shelf and rod bracket
26 ago 2014 Install longer screws into cleat next making sure that bracket is pushed tight to cleat with ... Shelf Supports
Place the closet pole into the bracket rod hooks make sure that the pole is level and securely in place Mark the position on the wall where the end of the
Place closet rod wall bracket at desired height Be sure both brackets are at same height Mark and drill 0 25 in holes DO NOT PUNCH HOLES
Secure each rod bracket with two rod bracket screws (#8 x 3/4”) B Install Closet Rod into bracket Drywall Installation: A Measure and mark rod bracket hole
Depress terminal block tab with ball point pen and insert wire ” 3 Use chop or hacksaw to cut rod to proper length DO NOT CUT LED CIRCUIT BOARD Deburr all
First remove the clothes pole and the center support bracket (if one exists) Next use a block of wood and a hammer at the underside of the shelf and tap
B DO NOT INSTALL ANY PART OF THE TRACK SYSTEM LESS THAN 5 FEET ABOVE THE FLOOR Slide the support brackets into the Runda Closet Rod extrusion Support
Parts required: Shelf backwall channel sidewall bracket universal pole cup shelf and rod angle brackets or shelf angle brackets closet rods closet rod end
support post use a shelf stop to end hang rod and shelf 1” on outside In any TS Pro Corner Rounder installation it is required to have no more than 3”
NOTE: If installing two Ventilated Shelves side-by-side to create one 4' Shelf the two Shelves will share the middle Shelf Bracket Install Closet Rods