d our Page 2 Packet Tracer - Configuring IPv6 Static and Default Routes © 2013 Cisco and/or its affiliates All rights reserved This document is Cisco
Part 1: Examine the Network and Evaluate the Need for Static Routing Part 2: Configure IPv6 Static and Default Routes Part 3: Verify Connectivity
Disable IPv4 addressing and enable IPv6 SLAAC for the PC network interfaces 15 6 2 Lab – Configure IPv4 and IPv6 Static and Default Routes Answers Lab
routes, 2 2 2 4 packet tracer configuring ipv4 static and, cisco lab exercises configuring ipv6 static and default, 7 1 3 6 lab configuring advanced eigrp for ipv4
Data VLAN – Data VLANs are commonly created for specific groups of users or devices Tracer - Configuring IPv6 Static and Default Routes 136 6 2 4 5 Lab
The following command parameters are not required to configure directly attached, fully specified, floating and default static routes • Refer to cisco com for
CCNA RSE Lab: 2 2 4 5 Configuring IPv6 Static and Default CCNA 4 Lab Activities Answers Solutions 2 1 2 5 Packet Tracer –
Cisco Public 2 Agenda IPv6 Routing Concepts in CCNA R&S; IPv6 Host Routing 4 6 2 4 4 Packet Tracer – Configuring IPv6 Static and Default Routes
7 1 2 4, Packet Tracer, Propagating a Default Route in EIGRP for IPv4 and IPv6, Optional 7 1 3 1, Syntax Checker, Configuring Bandwidth Utilization on R2
1 1 3 5, Packet Tracer, Configuring IPv4 and IPv6 Interfaces, Recommended Explain that the default-gateway command on the switch is used for management
This is a comprehensive Packet Tracer Physical Mode (PTPM) activity to Configure the IP address, subnet mask, and default gateway settings on PC-A
Step 2: Configure a static IPv6 address on the LAN interface A default gateway is not required for this topology; however, you can enter 192 168 1 1 to
A static route is used from the ISP to the gateway router, and a default route 2 Routers (Cisco 1941 with Cisco IOS Release 15 2(4)M3 universal image or
The Point-to-Point Protocol (PPP) is a very common Layer 2 WAN protocol What is the default serial encapsulation for a Cisco router?
21 déc 2015 · Configure advanced routing protocols to include EIGRP and Multi-Area OSPF lab 2 2 4 5: Configuring IPv6 Static and Default Routes 4
Device, Interface, IP Address / Prefix, Default Gateway R2, G0/0/0, 10 0 4 1 /24, N/A PC-4, NIC, 2001:db8:acad:5::10 /64, fe80::2:b