Page 1 of 3 Packet Tracer – Configuring Router-on-a-Stick Inter-VLAN Routing Configure interface F0/6 and F0/11 as access ports and assign VLANs
Assume S1 is already configured for router-on-a-stick inter-VLAN routing In Figure 6-2, con- Packet Tracer Exercise 6-1: Inter-VLAN Configuration
Packet Tracer: configuración de routing entre VLAN con router-on-a-stick Configure las interfaces F0/6 y F0/11 como puertos de acceso y asigne las VLAN
Then you will configure R1 with subinterfaces, 802 1Q encapsulation, and IP addressing All contents are Copyright © 1992–2007 Cisco Systems, Inc All rights
Create a basic configuration on a router Create an 802 1q trunk line between the switch and router to allow communication between VLANs Test the routing
Page 1 of 3 Packet Tracer - Configurarea Router-on-a-Stick Inter-VLAN Configurați interfața F0/6 și F0/11 ca porturi de acces și atribuiți VLAN-uri
23 avr 2018 · Configure Router-on-a-Stick Inter-VLAN Routing Instructions Answer pdf pka and inter-VLAN Routing Packet Tracer – Configure Layer 3
3 Objectifs du TP : - Configuration initiale du routage inter-VLAN : Logiciels : Cisco Packet Tracer, suite bureautique - Internet
3 Study of network IP 4 Connect the computers in Local Area Network 5 Study of basic network command and Network configuration commands 6
6 Scaling Networks v6 Labs Study Guide In this Packet Tracer activity, you will configure a router and a switch with basic settings and verify
Packet Tracer - Configure Router-on-a-Stick Inter-VLAN Routing Part 3: Test Connectivity with Inter-VLAN Routing S1(config-if)# int fa0/6
In this lab you will configure Inter-VLAN routing on the multi-layer switches in your pod and then a Layer 3 EtherChannel link to interconnect them
The primary course objective is learning to configure routers and switches for 3, VLANs 4, Routing Concepts 5, Inter-VLAN Routing 6, Static Routing
Topic 8: Packet Tracer – Investigating the TCP/IP and OSI Models in Action This information allows multiple Layer 3 protocols, such as IPv4 and IPv6,
How traditional switches work? Functionality of layer-3 switches VLAN (Virtual Local Area Network) concepts etc Lab 1 using Cisco packet tracer
Packet Tracer 5 0 is a standalone, medium-fidelity, simulation-based learning environment for networking novices to design, configure, and troubleshoot
ETHS-112, Communication Skills, 2, 1, 3, -- Note: Minimum of 4-6 weeks of industrial training related to CSE will be held after 6th semester; however,