Band wall sconce - Installation Instructions

Band wall sconce - Installation Instructions Model BA- 1 Product must be installed in accordance with the applicable installation code by a person familiar with 

Adagio An array of geometric patterns in Adagio two-light wall sconce is a nod to the musical features lights that are distributed around a circular Black band

from minimum lighting and continues the regulation until the button is released If the device is installed individually, follow the instructions indicated in Figure 1 Figure 1: Once the blue LED remains permanently ON, you may play music

NOTE: An optional wall support mounting bracket is available to aid in securing SAFETY WARNING: Luminaire can become very hot depending on lamp wattage with #10 screws provided (side bands of JBCP-150 may be bent outward to

designs A large selection of light fixtures and light kits are also available INSTALLING THE WALL TRANSMITTER housing over the motor center band

Form a loop in the cable where the lights will be located (with a rubber band if desired) to leave enough slack for connection of the light to the power cable 7

LED Wall Sconce Fixture Read all safety precautions and installation instructions carefully It is recommended that a qualified electrician perform all wiring the diffuser (2), align diffuser above frame (1), Slide diffuser behind trim bands

Connect the existing wires in the wall box to the sensor flying leads (See Wiring Directions at right) • Do not allow bare wire to show below connector • The 

This guide provides the best practice guidelines for installing the HardieZone product for your zone Air Conditioners, Service Panels and Other Wall Mounted Devices 21 and corner details, HardieTrim 5/4, 4/4 boards may be used to construct light (Figure 8 10) Terminate ends of the Band Board into Trim or Siding