can leave it open or add drawers) with two rods on one side (for short clothes Use a stud finder to locate the studs behind the closet walls Then use a tape measure to get the dimensions of your closet and the distance between the studs
ClosetOrganizer
Room Layout and Storage Space Requirements Step-in closets Dimensions • Minimum of 3' x 3' Shelf on side wall or back wall • Use other walls for optimal
closet design guide
the correct hardware needed to complete the installation based on your wall construction Take out any old shelving and/or closet rods Patch and repaint walls The “X” is to remind you, after drilling all holes, to go back and enlarge that hole with the distance between the two Standards, based on your custom design
elfa installation
the wall while leveling and marking the rest of the holes — While leveling The “X” is to remind you, after drilling all holes, to go back n Take out old shelving and closet rods Patch and spacing between the Hanging Standards is set
elfa installation
Each standard must be secured to the wall with one screw at the closest hole to the installing 16 in SuperSlide with Closet Rod Support always use 12 in brackets 2 ceiling and screw into wood header behind wallboard Stud installation is of shelves you want and the spacing between the shelves The closer the
inst
If individual shelves and/or closet rods are part of your design and order, you may need Measure the distance from the outer edge of the first base cabinet to the to the two horizontal installation rails, along the back of the wall cabinet at top
b f c efa f a b da da
There are three ways to install a shelf: Wall-to-Wall, Wall-to-Open, Choose the right hardware based on the length of the shelf and ends of closet rods
f a b f efe e e
the wall 4 Set shelf into Back Clips and snap down pin covers on Back Clips (if applicable) 5 Using a torpedo If distance is 36" or more between Support Braces, closet installations, it is recommended that Rubbermaid® Support Braces
fg z wire install guide
Outlets (Height off the ground, distance from left or right corner wall) • Light Switch Wall - with a back notch on the gables and rail system We can create Kids Closet triple rod – 28”, 56” and 80” with fixed shelf top shelf at 84” Fixed Shelf
Design Tips v
time using corner shelving or hang rods to make the most of the space. If the closet is shared plan one wall for each person with the back wall.
Wall Closet Support System -F Floor Mounted Back Outlet Closet Connection ... B = distance fixture studs should extend in front of finished wall .
engineers when laying out the spacing piping diagrams and wall space requirements cleaning around and in back of floor mounted water closets.
Water closet carriers anchor to the floor behind the finished wall effectively transferring the A = Distance nipple should extend beyond finished wall.
Jan 27 2006 Wall Reinforcement: Walls adjacent to and behind the water closet ... corner to a distance of six inches (6" = 152mm) beyond the widest part ...
(from front to back) on one end. Install Support. Brace 1" from end of shelf. See Support Brace installation in Wall To Wall instructions. 6. If distance is
n Ventilated Shelves and Closet Rods pg. 7 n Solid Shelving pg. 8-10 n Wall-Mounted Standards pg. 11 n Drawer Units pg. 12 elfa Easy Installation.
Attaches to the back of. Shelving to anchor Shelf to wall. Shelves are to be attached to walls with ClosetMaid Wall Clips ... Cross deck spacing.
Closet Rod Support (7) 856-00 Closet Rod Caps (6) 01-684 ... Place hang track on back wall so it is 7' (up from the floor) and against one side wall in.
Secure to the wall. Uprights. 7. Install upright closet panels ensuring each panel is level to the top of the shelf tower. Top shelf and fixed.
Closet Hardware Planning Guide