Command Line Interface Reference, Modes I - Q, StarOS Release 21 1 -NTP Configuration Mode Enables the use of the Network Time Protocol (NTP) for synchronizing the system clock Sets the NTP server to be used for the system
I Q CLI Reference chapter
ntp allow mode private 60 ntp authenticate 61 clock set, on page 18 This command is supported in the Cisco IOS Release 12 2SX train Support in a specific
bsm cr book
Step 1 configure terminal Enter global configuration mode Step 2 interface interface-id Enter interface configuration mode, and specify the interface to disable ntp disable Disable NTP packets from being received on the interface By default, all interfaces receive NTP packets
swadmin
Table 1: Feature History for Implementing NTP on Cisco IOS XR Software NTP synchronizes timekeeping among a set of distributed time servers and clients clock, or a GPS time source) directly attached, a “stratum 2” time server receives
b system management cg ncs x chapter
Simple Network Time Protocol 20 VINES Time Service 20 Hardware Clock 20 How to Set Time and Calendar Services 21 Configuring NTP 21 Restrictions 21
bsm t book
Configuring Orphan Mode 46 Configuring SNTP 47 Configuring VINES Time Service 48 Configuring the Time and Date 49 Setting the Hardware Clock 51
bsm mt book
To configure the router to use its own Network Time Protocol (NTP) master clock to synchronize with peers when an external NTP source becomes unavailable,
b system management cr crs x chapter
This chapter describes how to configure the Network Time Protocol (NTP) and authoritative time source, such as a radio clock or an atomic clock attached to a
system ntp
Table 1: Feature History for Implementing NTP on Cisco IOS XR Software NTP synchronizes timekeeping among a set of distributed time servers and clients clock, or a GPS time source) directly attached, a “stratum 2” time server receives
b system management cg asr x chapter
[normal-sync][version number] [key key-id] [source interface] [prefer] [maxpoll number] [minpoll number] [burst] [iburst Example: Router(config)# ntp peer
bsm sg book
To set the system time using the Network Time Protocol (NTP) server use the system the system time clock using an NTP server
To configure NTP on the router use the platform time-source ntp command. For information
Because the hardware clock is not as accurate as other time sources you should configure this command only when a more accurate time source (such as NTP) is
31 juil. 2017 Setting the System Clock 11. Configuring the Time Zone 11. Configuring Summer Time (Daylight Saving Time) 12. Configuring NTP 14.
The Network Time Protocol (NTP) synchronizes the time of day among a set of Access Devices NID Configuration Guide Cisco IOS 15.6(1)SN and Later.
10 déc. 2018 Setting the System Clock 10. Configuring the Time Zone 11. Configuring Summer Time (Daylight Saving Time) 12. Configuring NTP 16.
6 déc. 2012 Use the ntp broadcast client command to set your networking device to listen for NTP broadcast packets propagated through a network. For ...
You can configure the GPS time as the reference clock for NTP using the command ntp refclock gps. The GPS time acts as a stratum 0 source and the Cisco IOS
Use the ntp server command to individually specify the time serving hosts that you want your networking device to consider synchronizing with and to set your
Cisco IOS XR System Management Command Reference. OL-15797-02 broadcastdelay. To set the estimated round-trip delay between a Network Time Protocol (NTP)