Step 1 configure terminal Enter global configuration mode Step 2 interface interface-id Enter interface configuration mode, and specify the interface to disable ntp disable Disable NTP packets from being received on the interface By default, all interfaces receive NTP packets
swadmin
Network Time Protocol (NTP) is a protocol designed to time-synchronize devices within a network Cisco IOS XR software implements NTPv4 NTPv4 retains
b system management cg ncs x chapter
Cisco Nexus 1000V System Management Configuration Guide, Release This chapter describes how to configure the Network Time Protocol (NTP) and
system ntp
Sets the NTP server to be used for the system Only one NTP server may be active at any given time The system uses NTP to synchronize internal clocks on the
I Q CLI Reference chapter
Configuring the System as an Authoritative NTP Server 25 Updating Cisco IOS software--those features that are generally not specific to a particular protocol
bsm mt book
Simple Network Time Protocol 20 VINES Time Service 20 Hardware Clock 20 How to Set Time and Calendar Services 21 Configuring NTP 21 Restrictions 21
bsm t book
System Management Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6 7 x-Configuring Network Time Protocol
b system management cg asr x chapter
Because Cisco NX-OS cannot connect to a radio or atomic clock and act as a stratum 1 server, we recommend that you use the public NTP servers available on
b Cisco Nexus Series NX OS System Management Configuration Guide x chapter
synchronize to the remote system peer Allows only NTP control queries Cisco IOS XR software uses NTP Version 4, but the RFC for Version 3 (RFC 1305:
b system management cr crs x chapter
NTP is a protocol designed to time-synchronize a network of machines NTP runs over UDP, which in turn runs over IPv4 NTPv4 is an extension of NTP version
bsm sg book
Cisco ME 1200 Series Carrier Ethernet Access Devices NID Configuration Guide Cisco IOS 15.6(1)SN and Later Releases -Configuring NTP.
Cisco ME 1200 Series Carrier Ethernet Access Devices UCS Controller Configuration Guide Cisco IOS 15.6(1)SN and Later Releases -Configuring NTP.
Simple Network Time Protocol 33. VINES Time Service 33. Hardware Clock 34. Time Ranges 34. How to Configure Network Time Protocol 35. Configuring NTP 35.
Cisco Nexus 1000V System Management Configuration Guide Release 4.0(4)SV1(1). OL-19419-01. 8. Configuring NTP. This chapter describes how to configure the
31 juil. 2017 System Management Configuration Guide Cisco IOS XE Everest 16.6.x (Catalyst 9300 ... Configuring Broadcast-Based NTP Associations 17.
When you enable and synchronize the system time clock using an NTP server you must reboot the Cisco. Enterprise NFVIS so that the BMC or CIMC date and time
NTP is a protocol designed to time-synchronize a network of machines. NTP runs over UDP which in turn runs over IPv4. NTPv4 is an extension of NTP version 3
This chapter describes the Cisco IOS XR Network Time Protocol (NTP) commands used to perform networking device to synchronize to the remote system.
6 déc. 2012 NTP is a protocol designed to time-synchronize a network of machines. ... describes how to configure Network Time Protocol on CISCO devices.
Configuring NTP. Be aware that the Cisco NX-OS commands for this feature may differ from those commands used in. Cisco IOS. Note. Enabling or Disabling NTP.