be placed on the ends of Closet Rods to keep hangers in place 1 Shelf Installation There are two ways to install shelving: Open-ended or wall-to-wall For both
Installation Instructions
Each standard must be secured to the wall with one screw at the closest hole to the center of the SuperSlide with Closet Rod Support always use 12 in brackets 2 Hang track of shelves you want and the spacing between the shelves The closer the Cutting shelving, closet rods, and hang tracks Wire shelving can
inst
can leave it open or add drawers) with two rods on one side (for short clothes Use a stud finder to locate the studs behind the closet walls Then use a tape measure to get the dimensions of your closet and the distance between the studs
ClosetOrganizer
Round Hanger Bar End Caps are used with SuperSlide Wall Bar to connect Hanger Bars and allow clothes want and the spacing between the shelves
install
Keep everything associated with an activity in one place – work out clothes, ski Keep as much plumbing away from the walls where shelves will be mounted Most cost-effective closet system − it even costs less than “plank and pole ”
closet design guide
Use wall hanging system to design the space so you are using less material Light size and location (Width, height, height off the ground, and distance from left or Kids Closet triple rod – 28”, 56” and 80” with fixed shelf top shelf at 84”
Design Tips v
Closet Rods page 11 For closets, hang clothes that you are keeping on a garment rack Please note that any solution used away from the wall requires
elfa installation
the wall while leveling and marking the rest of the holes — While n Take out old shelving and closet rods spacing between the Hanging Standards is set
elfa installation
wall, all other components simply hang from the Hanging Rail Constructed continuous-slide hanging rod anywhere within the closet •Constructed of Spacing: Every 32” for normal loads, and every 16” for heavier loads, including pantry
freedomRailTrainingManual
Mark the position on each wall for the pole sockets. Determine the width of the closet rod needed to span the brackets taking care to include the distance
Wall Closet Support System X = distance closet is to be located from finished wall ... gasket and hang the water closet onto the threaded rods.
Select the hardware that is right for your wall type: Determine length and spacing of standards ... Cutting shelving closet rods
engineers when laying out the spacing piping diagrams and wall space requirements for plumbing fixtures. The Smith system offers the engineer an option of
n Ventilated Shelves and Closet Rods pg. 7 n Solid Shelving pg. 8-10 n Wall-Mounted Standards pg. 11 n Drawer Units pg. 12 elfa Easy Installation.
be placed on the ends of Closet Rods to keep hangers in place. 1. Shelf Installation. There are two ways to install shelving: Open-ended or wall-to-wall.
installation in Wall To Wall instructions. 6. If distance is 36" or more between Support Braces Use on hang rod wire for all Linen
Refer to Closet Layout & Installation Round Hanger Bar End Caps are used with SuperSlide Wall ... 4 small and 4 large are needed for 12” Shelf & Rod.
For closets hang clothes that you are keeping on a garment rack Please note that any solution used away from the wall requires.
Water Closet Carrier System Installation Instructions . X = distance closet is to be located from finished wall ... Hang the EZCUTGUIDE (purchased.
Closet Hardware Planning Guide