Keep everything associated with an activity in one place – work out clothes, ski Keep as much plumbing away from the walls where shelves will be mounted Most cost-effective closet system − it even costs less than “plank and pole ”
closet design guide
Each standard must be secured to the wall with one screw at the closest hole to the center of the SuperSlide with Closet Rod Support always use 12 in brackets 2 Hang track of shelves you want and the spacing between the shelves The closer the Cutting shelving, closet rods, and hang tracks Wire shelving can
inst
Spacing of Standards Standards are Each Standard must be secured to the wall with one screw at the hacksaw Closet Rods can be cut using a pipe cutter
Installation Instructions
Use wall hanging system to design the space so you are using less material Light size and location (Width, height, height off the ground, and distance from left or Kids Closet triple rod – 28”, 56” and 80” with fixed shelf top shelf at 84”
Design Tips v
For closets, hang clothes that you are keeping on a garment rack outside the Please note that any solution used away from the wall requires feet on both sides
elfa installation
Long Hang (LH) – single pole with one to two shelves above, used mostly for Baseboards on the side walls should be cut away for maximum use of space
CCCP DesignGuidelines
can leave it open or add drawers) with two rods on one side (for short clothes Use a stud finder to locate the studs behind the closet walls Then use a tape measure to get the dimensions of your closet and the distance between the studs
ClosetOrganizer
1 HANGING MORE CLOTHES Double Hang is Round Hanger Bar End Caps are used with SuperSlide Wall Brackets Use flat 4 small and 4 large are needed for 12” Shelf Rod want and the spacing between the shelves The closer
install
SPACING GUIDELINES FOR CLOTHING AND GENERAL STORAGE per foot Numbers indicate how many items will fit PER FOOT of closet width when allowing 1-1/2" per hanger 16" Shelf with Hanging Rod 12" Open Slide® Hanging Shelf Hanging Shelf # Feet Storage Linen Shelf Back Clips Side Wall Brackets
Design guide
A typical closet can include two levels of hanging rods. 9-inches (24-inches is standard) away from the back wall for hanging. When spanning an opening ...
n Ventilated Shelves and Closet Rods pg. 7 n Solid Shelving pg. 8-10 n Wall-Mounted Standards pg. 11 n Drawer Units pg. 12 elfa Easy Installation.
from the closet floor vertically to a height of 1.8 m (6 ft) or to the highest clothes-hanging rod and parallel to the walls at a horizontal distance of 600
Select the hardware that is right for your wall type: Determine length and spacing of standards ... Cutting shelving closet rods
Select the hardware that is right for your wall type: 2. HANG TRACK LOCATION Use a corner closet rod to allow clothes to slide.
be placed on the ends of Closet Rods to keep hangers in place. 1. Shelf Installation. There are two ways to install shelving: Open-ended or wall-to-wall.
Once the Hanging Rais is mounted to the wall all other com- Snap easily into open ends of Clothes Rod
48" Inner Clothes Rod Drill 1/8" pilot hole and fasten both screws (use wall anchor and 3/8" ... Slide second hang rail as far right to the wall as ...
engineers when laying out the spacing piping diagrams and wall space requirements for plumbing fixtures. The Smith system offers the engineer an option of
5 Install Adjustable Clothes Rods sure each shelf slides back as far as possible before locking shelves into ... On closet wall locate all wall.
Closet Hardware Planning Guide