The maximum variation in the period of a clock signal, measured at an interval of 1 period from the reference (trigger) edge The Calibration Tolerance is defined
Technical Dictionary
1 Frequency tolerance is defined in Article 1 and is expressed in parts in 106, unless otherwise indicated 2 The power shown for the various categories of
ap
applicable operational frequency tolerance band and should not exceed the applicable generation and load change band for more than one minute or exceed
REL The Frequency Operating Standard stage one final for publi
The frequency tolerance is expressed in parts in 106 or in hertz 2 The power shown for the various categories of stations is the peak envelope power for
LawGetFile.ashx?FileId= &lan=E&sa=U&ved= ahUKEwjr b vsb vAhWKsBQKHYClCg QFjAKegQIBBAB&usg=AOvVaw XNZlE BsvVxIB PV E">[PDF] Appendix Table of Transmitter Frequency Tolerances
The IEEE Std 802 15 4 requires that frequency tolerances for a wireless node must be kept within ±40 ppm accuracy The Bluetooth Low Energy standard requires
AN
The frequency tolerance limits, again, did not reach beyond 40 GHz New spurious emission limits come into effect on that same date for flew transmitters operating
Voltage tolerance selectable 200/208/220/240 V. Rated frequency. 50 or 60 Hz. Frequency tolerance. ± 2% (± 0.05 Hz in battery mode). Power factor.
400 ± 20% at full load (for wider tolerances additional conditions apply). Frequency tolerance. 40 - 72 Hz. Power factor 50 / 60 Hz. Frequency tolerance.
Frequency tolerance. 40 - 72 Hz. Power factor. 0.99. BY PASS. Rated voltage. 380 / 400 / 415 V three-phase + N. Rated frequency. 50 or 60 Hz (selectable).
tolerances are generally maintained for normal conditions and are relaxed somewhat (the right side of the figure) frequency is maintained near 60 Hz by ...
Rated voltage. 3P+N 400 V. Voltage tolerance. ± 20 % (-40 % @ 70 % of nominal load). Rated frequency. 50/60 Hz ± 10 %. Power factor / THDI. 0.99 / <2.5 %.
Frequency tolerance. 40 - 72 Hz. Power factor. 0.99. BY PASS. Rated voltage. 380 / 400 / 415 V three-phase + N. Rated frequency. 50 or 60 Hz (selectable).
4 juin 2021 Input frequency. 50 / 60 Hz. Frequency tolerance (Generator operation). -30% / +40%. Frequency tolerance (Grid export).
50/60 Hz. Frequency tolerance. ± 5 Hz. Power factor / THDI. 0.93 / < 4.5%. 0.94 / < 5%. OUTPUT. Rated voltage. 380 V - 400 V - 415 V. Voltage tolerance.
Voltage tolerance. 240 V to 480 V(2). Rated frequency. 50/60 Hz ± 10%. Power factor / THDI. 0.99 / < 3%. OUTPUT. Rated voltage.
50/60 Hz. Frequency tolerance. ± 10%. Power factor / THDI(3). 0.99 / < 3%. OUTPUT. Rated voltage. 1ph + N: 230 V (can be configured 220/240 V).
NETYS RT-M