Calibration required. Return to a service center to be calibrated. Wrench settings were not saved once battery was removed. Battery was removed before.
The Sub-Scanner must remain flat against and in con- tact with surface during entire scan. If CALIBRATION. ERROR is dis- played the tool was placed in an area.
To avoid any calibration problems: Never turn the wheel or press on the pedals when connecting the racing wheel or starting a game. - Always connect the pedal
11) Calibrate the sensor according to chapter 9 (Calibration) Norme NEMA 5-15p États-Unis Canada
First screw the clamp to the throttle quadrant using the four screws provided.You can screw the clamp to one of two sides of the.
If you see CAL FAIL repeat the calibration process. Calibrating Altitude or Barometer and Setting the Weather. You should calibrate either the Altimeter (MAN-
Calibrate measuring tool. 28. 3. Check leveling accuracy. 27. 4a. Deviation after calibration is within the maximum permitted limits of ±1/8-in (±3 mm):.
This manual includes specifications for the. GOL Series auto level. Verify the calibration of the instrument. Before initial use follow the test shown in the
14 thg 11 2012 environmentally compatible and should be taken for central ... was calibrated
4. When calibrating position the side laser beam (on the calibration port side) on the vertical surface at the opposite end of the.
2465-20 2466-20 M12 FUEL™ DIGITAL TORQUE WRENCHES