Each standard must be secured to the wall with one screw at the closest hole to the SuperSlide with Closet Rod Support always use 12 in brackets 2 Hang track of shelves you want and the spacing between the shelves The closer the
inst
Standard: Double hang entire closet (84” for top shelf and 42” for bottom shelf ) Keep as much plumbing away from the walls where shelves will be mounted
closet design guide
Spacing of Standards Standards are Each Standard must be secured to the wall with one screw at the hacksaw Closet Rods can be cut using a pipe cutter
Installation Instructions
can leave it open or add drawers) with two rods on one side (for short clothes like shirts, pants, sport coats, etc ) and one rod Use a stud finder to locate the studs behind the closet walls Then use a tape measure to get the dimensions of your closet and the distance between the studs Measure your longest short clothes
ClosetOrganizer
Wall thickness will vary by installation 4 Install driver in a readily accessible location The supplied standard wire harness is 8', 18AWG Remote driver mounting
Closet Rod Install Instructions
Wall-Mounted Standards page 15 Take out any old shelving and/or closet rods Patch and Please note that any solution used away from the wall requires
elfa installation
the wall while leveling and marking the rest of the holes — While n Take out old shelving and closet rods spacing between the Hanging Standards is set
elfa installation
a shelf Or, create shoe shelves using inverted SuperSlide shelving Round Hanger Bar End Caps are used with SuperSlide Wall spacing of standards
install
a variety of styles and finish choices in closet rods and pull outs galore, you can turn this underrated room into We carry a large variety of shelf standards, clips and brackets, counter top Also features one screw hole above lower dowel to secure to wall, screw Distance from bottom of shelf to bottom of rod: 2-9/16”
shs catalog closet
A typical closet can include two levels of hanging rods. 9-inches (24-inches is standard) away from the back wall for hanging. ... bracket spacing.
in front of finished wall . Dimensions below based on B = 3/8" . Let A = depth of recess in closet. X = distance closet is
Each standard must be secured to the wall with one screw at the closest SuperSlide® with Closet Rod & Support always use 12 in. brackets.
n Ventilated Shelves and Closet Rods pg. 7 n Solid Shelving pg. 8-10 n Wall-Mounted Standards pg. 11 n Drawer Units pg. 12 elfa Easy Installation.
Standard. Bracket. Closet Rod. Closet Rod Support. Closet Rod Cap. Shelf End Cap. Choose Your Hardware. Drywall. Drill 1/2 in. holes and secure to the wall
Spacing of Standards. Standards are available in Each Standard must be secured to the wall with ... Closet Rods can be cut using a pipe cutter.
16" Shelf Bracket. • 48" Hang Rail. • 22" Hang Rail Cover. • Closet Pole Kit. • 48" Wall Standard. • Closet Pole Hook. • Mounting Screws.
Watts Industry Standard Water Closet Carriers support wall hung "off the floor" water closets A = Distance nipple should extend beyond finished wall.
engineers when laying out the spacing piping diagrams and wall space requirements for plumbing fixtures. The Smith system offers the engineer an option of
all other ShelfTrack closet installations standard spacing should be no more than Standard. Bracket Set. Decorative Shelf. Adjustable. Closet Rod Kit.
Closet Hardware Planning Guide