Velcro strips along the edges Rotate the Wall Panel into position Attach the next Pillar to the Wall Panel so that it is ˜at against the front face of the Wall Panel Rotate the Pillar into position M2S-2020-1_BrandMD Skincare Page 4 Assembly Instructions: 20’x20’ Multi Section Shelf and Tower Display
Indoor HD Display AC Power Adapter for Display Wall Mounting Bracket (optional) 2 In the battery compartment of the AcuRite Rear solar panel facing south
a terminal compartment of the “e” type of protection (increased safety) The state-of-the-art display technology guarantees an optimum contrast, even with large viewing angle The front panel fitting assures easy installation Upon request, the devices are also available as turn-key system solutions in a stainless steel
panel IMPORTANT: The display screen on the dispenser control panel will turn off automatically and enter “sleep” mode when the control buttons and dispenser pads have not been used for 2 minutes or more While in “sleep” mode, the first press of a control button will only reactivate the display screen, without changing any settings
compartment with the 8mm DC barrel connector plugged into the port inside the compartment, or it can be moved out of the compartment and plugged into the front panel input port CHARGE ME NOW: Before using or storing, plug your Goal Zero Yeti into the wall until it is fully charged Keep your Goal Zero Yeti plugged in when not in use
User selectable control panel display options provide information to indicate unit operation 3 DIGITAL ROOM TEMPERATURE THERMOSTAT: A built-in digital thermostat monitors room temperature When it is desired to monitor temperature at a location in the other than at the heater, a remote wall sensor is available 4 CONTROL PANEL DIGITAL DISPLAY:
1 Locate the thermostat on an inside wall, about 5 ft (1 5m) above the floor, and in a room that is used often 2 Do not install it where there are unusual heating conditions, such as: in direct sunlight; near a lamp, radio, television, radiator, register, or fireplace; near hot water pipes in a wall; near a stove on the other side of a wall 3
faceplate and a third one located inside the storage compartment under the top lid One of the front ports and the port inside the storage compartment are round 8mm ports designed to be used with Goal Zero Solar Panels or wall charger Each 8mm input port can handle up to 120W The Anderson Power Pole port is designed to be used with larger
E – Wiring Compartment Reset Button – This button will reset the controller All programmed data will remain intact 9-Volt Battery – The alkaline battery will maintain the controller memory if power to the transformer is disconnected However, the battery will not operate any of the watering activity (not included)
4 Remove the front panel retaining screws located on the bottom of the UPS 5 Slide the battery compartment cover (front panel) completely off of the unit 6 Disconnect the battery wires from the batteries 7 Remove the batteries from the compartment 8
compartment may catch fire Never store Press the - button until 0?00 is shown in the display panel 3 The hook-in racks in each case are fixed to the side walls of the cooking Para asar directamente sobre la parrilla, colocar la bandeja
C
Display The display is structured so that the information can be shaped heating elements in the back panel evenly around the cooking compartment Ensure that the baking tin does not stand directly in front of the openings in the cooking compartment back wall La bandeja pastelera y la parrilla pastelera y de asado
F
holder is made of transparent plexiglass and is completely re- movable for a better single compartment allows for a high and constant perfor- mance, the Parrilla en acero cromado con empuñaduras atérmicas y franjas STORAGE 1, 5 KG • 1350 RPM Double wall plastic-plate panels, insulation in polyurethane
Preparazione
DO NOT operate the clamshell grill unless all service and access panels the anchor assembly remains fastened to the back wall of the grill bay 3- compartment sink to Nettoyant à chaudpour grils Limpiador de parrilla Upon Completion of auto calibration, platen raised automatically, and display reads “ READY”
GL MWE spm