Rectification is a remedy exercised in the court's discretion to re-write mistaken wording in a legal document so that it accords with what the parties to the document had intended. In a pensions context, rectification is often, but not always, sought by the employer and the document is usually a deed or the rules of the scheme.
The concept of rectification is crucial to the operation of modern electronic circuits. Most electronic devices such as a TV or computer require a fixed, unchanging DC voltage to power their internal circuitry. In contrast, residential and commercial power distribution is normally AC. Consequently, some form of AC to DC conversion is required 1.
As with single-phase rectification, three-phase rectification uses diodes, thyristors, transistors, or converters to create half-wave, full-wave, uncontrolled and fully-controlled rectifier circuits transforming a given three-phase supply into a constant DC output level.
Abstract: Synchronous rectification is an effective method to improve efficiency and reduce loss of LLC resonant converter.
The advantage here is that a three-phase alternating current (AC) supply can be used to provide electrical power directly to balanced loads and rectifiers. Since a 3-phase supply has a fixed voltage and frequency it can be used by a rectification circuit to produce a fixed voltage DC power which can then be filtered resulting in an output DC voltag
Having seen that a 3-phase supply is just simply three single-phases combined together, we can use this multi-phase property to create 3-phase rectifier circuits. As with single-phase rectification, three-phase rectification uses diodes, thyristors, transistors, or converters to create half-wave, full-wave, uncontrolled and fully-controlled rectifi
A half-wave 3-phase rectifier is constructed using three individual diodes and a 120VAC 3-phase star connected transformer. If it is required to power a connected load with an impedance of 50Ω, Calculate, a) the average DC voltage output to the load. b) the load current, c) the average current per diode. Assume ideal diodes. a). The average DC load
The full-wave three-phase uncontrolled bridge rectifier circuit uses six diodes, two per phase in a similar fashion to the single-phase bridge rectifier. A 3-phase full-wave rectifier is obtained by using two half-wave rectifier circuits. The advantage here is that the circuit produces a lower ripple output than the previous half-wave 3-phase recti
A 3-phase full-wave bridge rectifier is required to fed a 150Ω resistive load from a 3-phase 127 volt, 60Hz delta connected supply. Ignoring the voltage drops across the diodes, calculate: 1. the DC output voltage of the rectifier and 2. the load current. 1. the DC output voltage: The RMS (Root Mean Squared) line voltage is 127 volts. Therefore the
We have seen in this tutorial that three-phase rectification is the process of converting a 3-phase AC supply into a pulsating DC voltage as rectification converts the input power supply of a sinusoidal voltage and frequency into a fixed voltage DC power. Thus power rectification changes an alternating supply into a unidirectional supply. But we ha