[PDF] closet hanger rod distance from wall

Opt for a closet rod depth of at least 12 inches. If you don't leave sufficient space between the rod and the rear wall, one side of all garments will wrinkle from being bunched up against it. You can avoid this clothing disaster by mounting the rod at least 12 inches from the rear wall of the closet.
View PDF Document


  • How far off wall should hanger rod be?

    As a rule, place the top rod 80 to 82-inches up from the floor and the bottom rod about 40-inches up from the floor.
    For a single rod application, plan 60-inches from the floor for placement.
    You will need at least 1-foot, 9-inches (24-inches is standard) away from the back wall for hanging.

  • How much clearance do you need from closet rod to shelf?

    Allow about 24 inches of space behind the rod to hang garments and 4 inches above the rod before you add shelving, which allows for easy hanging of clothes.

  • How much clearance do you need from closet rod to shelf?

    Shelves for folded clothes should be placed around 12 inches apart. 84 inches is considered the minimum height to hold double hanging rods.
    Blouses and shirts will take up about 1 inch of rod space, pants and skirts around 1 1/4 inches and dresses, jackets and suits about 2 to 3 inches.

View PDF Document




Closet Hardware Planning Guide

Mark the position on each wall for the pole sockets. Determine the width of the closet rod needed to span the brackets taking care to include the distance 



Carrier Systems

Wall Closet Support System X = distance closet is to be located from finished wall ... gasket and hang the water closet onto the threaded rods.



ShelfTrack® Installation Tips

Select the hardware that is right for your wall type: Determine length and spacing of standards ... Cutting shelving closet rods



Water Closet Supports Technical Data

engineers when laying out the spacing piping diagrams and wall space requirements for plumbing fixtures. The Smith system offers the engineer an option of 



Top Track Hardware and Hanging Standards

n Ventilated Shelves and Closet Rods pg. 7 n Solid Shelving pg. 8-10 n Wall-Mounted Standards pg. 11 n Drawer Units pg. 12 elfa Easy Installation.



2. Hang Track Location 3. Determine Length and Spacing of

be placed on the ends of Closet Rods to keep hangers in place. 1. Shelf Installation. There are two ways to install shelving: Open-ended or wall-to-wall.



Installation Guide - Wire Storage System

installation in Wall To Wall instructions. 6. If distance is 36" or more between Support Braces Use on hang rod wire for all Linen



Wire Shelving Pjt Planner

Refer to Closet Layout & Installation Round Hanger Bar End Caps are used with SuperSlide Wall ... 4 small and 4 large are needed for 12” Shelf & Rod.



Instructions for Easy Installation & Assembly

For closets hang clothes that you are keeping on a garment rack Please note that any solution used away from the wall requires.



Carrier Systems

Water Closet Carrier System Installation Instructions . X = distance closet is to be located from finished wall ... Hang the EZCUTGUIDE (purchased.