AL 7000 Manual for 8pp PDF 3. 4. 5. 6. 1.

Untitled

ACE III Premium. Bedienungsanleitung. Operating manual. Notice d'utilisation. acE in der Bedienungsanleitung verwendet werden. ac. ACE III. ALCOSCAN.

Bedienungsanleitung

chen Bedienung des ACE III zu erkennen und entsprechend zu reagieren. L'ACE ALCOSCAN ACE III est un appareil simple et convivial d'éthylotest.

Home Health UK

AL-6000 USER'S MANUAL Three (3) step warning beeps for alcohol detection ... Do NOT use the AlcoScan AL-6000 as a tool to drink and drive.

ACE II Basic plus

ACE II Basic plus www.alkomat.net. Atemalkoholtester. Bedienungsanleitung – DE. Breathalyzer. Operating Manual – EN. Alcotest. Notice d'utilisation – FR.

AlcoMate Prestige (Model AL6000) USERS MANUAL

The AlcoMate Prestige is intended to measure alcohol in human breath. Readings obtained by this USER'S MANUAL. Mouthpiece Slot ... 3 Digit %BAC Reading ...

ACE AL7000

3. Wichtige Hinweise zur Kalibrierung. Jeder Alkoholtester der bei ACE Vorankündigung und Anpassung der Bedienungsanleitung geschehen und ist kein ...

AL 7000 Manual for 8pp

3. 4. 5. 6. 1. 2. 3. 4. 5. “Flow” indicates the breath sample was not strong enough for measurement. Turn on unit again: blow strongly and steadily.

Dräger Alcotest 6510 - Dual Limit Breath Alcohol Screening Device

09-Dec-2010 3. Close battery cover. 4.2. Batteries to be used ... 3. 00723840.eps. OK. Alcotest 6510. M. Remove packaging com- ... manual sampling.

Users Manual

The AlcoScan Model AL7000 analyzes a breath sample to detect alcohol in the lungs. This reading is then converted to blood alcohol concentration (BAC).

ACE AL6000

3. Zur Kalibrierung. Jeder Alkoholtester der bei ACE Instruments gekauft digung und Anpassung der Bedienungsanleitung geschehen und ist kein Grund zur ...

123456

12345
"Flow" indicates the breath sample was not strong enough for measurement.

Turn on unit again: blow strongly and steadily

during sampling.

If you make over 300 test the unit will display

"CAL" for 15 seconds while warming up for the test'CAL" indicates it is time for sensor replacement. "bAt" indicates the battery power is low.

Replace batteries.

Range 0.000 to 2.000 mg/l

Accuracy +/- 0.02% to 0.10% BAC

Sensor Oxide semiconductor

Power Two 1.5v AA alkaline batteries

Testing capacity Approx 100 - 200 with new batteries

Operating temperature 10-40ºC

Warm-up Less than one minute

Display 3-digit LCD

Size (mm) 105 H x 50 W x 18 D

Weight 98g

Sensor module Sensor module should be

replaced after approximately

300 tests or if damaged by

improper testing of handling. Breathalyzer, mouthpieces (5), AA alkaline batteries (2), pouch, hand strap, 12V DC in-car charger and manual.

12V DC in-car power adapter.

Two spare mouthpieces can be stored

inside the unit. DRINK DRIVING LIMITS as displayed by this breathalyzer

England & Wales 0.35 mg/l

Scotland, Ireland, France 0.22 mg/l

These are the legal maximum. ANY alcohol in the body will impair

judgement; the only safe limit is ZERO. DO NOT DRINK AND DRIVE!1 Pr ess the power switch. Press and hold the power switch

displays the total accumulated tests.

2 Warm up.

3 Bl ow into the mouthpiece for four seconds until the unit

beeps twice.

4 The result is display ed for 15 seconds.

5 Unit turns off automatic ally.

123456

Ensure power is off.

1 Open the sensor c over.

2 Locat e sensor module.

3 Remov ed PCB.

4 Insert new sensor modul e into original position.

6 Close sensor c over and test unit.

quotesdbs_dbs26.pdfusesText_32

[PDF] AL 7000 Manual for 8pp 3. 4. 5. 6. 1.

123456

Turn on unit again: blow strongly and steadily

If you make over 300 test the unit will display

Replace batteries.

Range 0.000 to 2.000 mg/l

Accuracy +/- 0.02% to 0.10% BAC

Sensor Oxide semiconductor

Power Two 1.5v AA alkaline batteries

Operating temperature 10-40ºC

Warm-up Less than one minute

Display 3-digit LCD

Size (mm) 105 H x 50 W x 18 D

Weight 98g

Sensor module Sensor module should be

300 tests or if damaged by

12V DC in-car power adapter.

Two spare mouthpieces can be stored

England & Wales 0.35 mg/l

Scotland, Ireland, France 0.22 mg/l

2 Warm up.

3 Bl ow into the mouthpiece for four seconds until the unit

4 The result is display ed for 15 seconds.

5 Unit turns off automatic ally.

123456

Ensure power is off.

1 Open the sensor c over.

2 Locat e sensor module.

3 Remov ed PCB.

4 Insert new sensor modul e into original position.

6 Close sensor c over and test unit.