[PDF] Attempt to Upgrade Firepower Devices Results in Failure "

View - Download Attempt to Upgrade Firepower Devices Results in Failure "

Previous PDF

Next PDF

Attempt to Upgrade Firepower Devices

Results in Failure "006_check_snort.sh" Contents

Introduction

Problem

Analysis

Solution

Related Information

Introduction

This document describes a specific upgrade failure scenario seen on Firepower Threat Defense (FTD) when the upgrade procedure is not properly followed. It also covers the proposed solution.

Problem

An attempt to perform an upgrade results in the

Update Install failed

error as shown in this screenshot:

Analysis

In the FTD Troubleshoot file, under this path ('x' characters will vary), there is a file named status.log

The file contains the transcript of the upgrade:

state:running ui:Upgrade has begun. ui:[ 0%] Running script 000_start/000_check_update.sh... ui:[ 1%] Running script 000_start/100_start_messages.sh... ui:[ 3%] Running script 000_start/105_check_model_number.sh... ui:[ 4%] Running script 000_start/106_check_HA_sync.pl... ui:[ 5%] Running script 000_start/107_version_check.sh... ui:[ 7%] Running script 000_start/109_check_HA_MDC_status.pl... ui:[10%] Running script 000_start/125_verify_bundle.sh... ui:[12%] Running script 000_start/400_run_troubleshoot.sh... ui:[13%] Running script 200_pre/001_check_reg.pl... ui:[14%] Running script 200_pre/002_check_mounts.sh... ui:[14%] Running script 200_pre/003_check_health.sh... ui:[15%] Running script 200_pre/006_check_snort.sh... ui:[15%] Fatal error: Error running script 200_pre/006_check_snort.sh <-- the problem Additionally, under this path there is a file named

006_check_snort.sh.log

which further describes the reason for the failure:

In this case, the file contains these messages:

Entering 200_pre/006_check_snort.sh...

Snort build is too old.

Please apply AC Policy from FMC before attempting upgrade.

There are a few reasons why this error can occur:

Your Firepower Management Center was updated; however, the sensor which attempts to upgrade has not had a new policy deployment pushed out towards it. l Your Firepower Management Center has updated its Snort Rule Update (SRU); however, the sensor which attempts to upgrade has not had a new policy deployment pushed out towards it l

In either situation the resolution is the same.

Solution

Once you have verified that the device encounters this issue, simply deploy a policy to the affected device in order to resolve the error. From Firepower Management Center, check the box next to the device to be upgraded and click

Deploy

Once this is performed, proceed with your upgrade.

Related Information

Cisco Firepower Management Center Upgrade Guidel

Technical Support & Documentation - Cisco Systemslquotesdbs_dbs27.pdfusesText_33

[PDF] L allocation aux adultes handicapés attribuée dans les départements

[PDF] 2015 : NOUVELLE STRATEGIE NUMERIQUE DE L OFFICE DE TOURISME

[PDF] Réunion de rentrée des Masters du Pôle Info 3

[PDF] SAP Customer Success Story Services B2Boost. B2Boost: Lier des quantités d'informations considérables à des rapports clairs en temps réel

[PDF] GUICHET PROFESSIONNEL

[PDF] THESES EN COTUTELLE INTERNATIONALE

[PDF] ASSURANCE QUALITE AUDIT ET INSPECTION. Yamina Boulahdaj Référente qualité URC-CIC Paris Centre Cochin-Necker

[PDF] Commentaire du. Règlement Général. Commentaire du Règlement Général publié en 2003, révisé la dernière fois en 2013 1

[PDF] REGLEMENT GENERAL PREAMBULE. de l assurance obligatoire de la responsabilité civile découlant de l usage du véhicule automoteur qui y est décrit ;

[PDF] REFERENTIEL DE L'AUDIT

[PDF] Guide utilisateur pour la remise de cartes

[PDF] NORME INTERNATIONALE D AUDIT 220 CONTRÔLE QUALITE D UN AUDIT D ETATS FINANCIERS

[PDF] CHAPITRE 2. Population, ménages et familles

[PDF] Convention relative à la constitution et au fonctionnement de la Maison de Justice et du Droit de Sénart

[PDF] SUIVI DES ACTIVITÉS PROMOTIONNELLES