[PDF] HP StorageWorks DAT RemovableTape Drive Getting Started Guide

Which HP StorageWorks DAT internal tape drive models are supported?

• This guide describes how to install and operate the following HP StorageWorks DAT internal tape drive models: •HPStorageWorksDAT72 •HPStorageWorksDAT40 Which operating systems are supported? HP StorageWorks DAT drives can be connected to servers running under Windows®, NetWare, UNIX, Tru64 and Linux.

Where can I get HP StorageWorks tape drivers?

• Windows drivers can be obtained from the HP StorageWorks Tape CD-ROM or from www.hp.com/support. For support on UNIX systems, see the UNIX Configuration Guide on the HP StorageWorks Tape CD-ROM. (Backup software that states support for HP StorageWorks DAT tape drives also provides the required drivers.)

How do I connect my StorageWorks DAT tape drive to my server?

• A wide VHD-to-HD SCSI cable is provided to connect your HP StorageWorks DAT tape drive to a VHD SCSI port on an LVD SCSI bus. If your server has an HD SCSI port, you must either purchase and install a VHD-to-HD adapter or use an HD-to-HD cable instead of the supplied cable. Refer to our web site for recommended products: www.hp.com/go/connect.

What is the internal buffer size of a DAT tape drive?

• You may need to tune the transfer, buffer and block size settings to optimize the speed that the application writes data to the tape drive. HP StorageWorks DAT tape drives have an internal buffer of 8 MB. dds-internal-frame6.fm Page 36 Monday, January 5, 2004 5:01 PM