[PDF] Élimination des colorants des eaux résiduaires de lindustrie textile





Previous PDF Next PDF



Thème Etude de lélimination des colorants de textiles par

adsorption sur des différents charbons actifs préparés à base des noyaux de dattes. Page 2. Remerciement. Nous tenons tout d'abord à remercier en premier lieu 



MEMOIRE MAGISTER THEME Elimination des colorants

En effet l'adsorption sur charbons actifs présente de nombreux avantages : elle permet l'élimination d'une large gamme de polluants



Elimination dun colorant par adsorption sur lamidon

Elimination d'un colorant par adsorption sur l'amidon Chapitre I : généralités sur l'adsorption ... II.4.2 Toxicité par les colorants alimentaires.



ELIMINATION DUN COLORANT DES EFFLUENTS DE L

Abstract - Removal of a dye from textile effluents by adsorption. The thermodynamics and the kinetics of adsorption on clay material of methylene blue in 



Elimination dun colorant par adsorption sur support solide et par

Elimination d'un colorant par adsorption sur support solide et par I.5 Méthodes de traitement des colorants (action curative): .



Elimination du colorant bleu de méthylène par adsorption

Elimination du colorant bleu de méthylène par I.3 Procédés d'élimination des colorants . ... I.4.5 Modèles mathématiques appliqués à l'adsorption .



ADSORPTION DUN COLORANT BLEU DE METHYLENE EN

GENERALITES SUR L'ADSORPTION ET LES ADSORBANTS. II.1. Introduction . plus favorable pour l'élimination des colorants car elle est considérée comme un.



Elimination du colorant bleu de méthylène en solution aqueuse par

L'adsorption est l'un des procédés les plus utilisés dans le monde en vue d'élimination des colorants dans les réseaux des eaux usées. Cependant



Élimination des colorants des eaux résiduaires de lindustrie textile

7 mar. 2022 Elimination des colorants textiles par la bentonite et les sels d'aluminium ... Mots clés : adsorption bentonite





MEMOIRE - univ-tlemcendz

Elimination des deux colorants par adsorption sur un matériau issu de la coquille d’escargot Nous dédions ce travail : A nos parents qui nous sont très chers et



Elimination du colorant bleu de méthylène par adsorption

Aujourd’hui il existe plus de 10 000 colorants ayant des structures chimiques diverses classés comme anioniques cationiques et non ioniques en fonction de la charge ionique sur les molécules de colorant Les colorants cationiques sont plus toxiques que les colorants anioniques



Searches related to elimination des colorants par adsorption PDF

Pour cela notre objectif de ce travail est l'étude de l’élimination de colorant bleu de méthylène par l’adsorption sur charbon actif afin de déterminer les principaux points suivants: Déterminer l'influence de quelques paramètres tels que: le pH la masse d'adsorbant La

Quel est le rendement d’adsorption des colorants?

Comme nous pouvons le constater, d’une façon générale, le rendement d’adsorption des colorants augmente avec l’augmentation de la masse de l’adsorbant utilisé. En effet, une masse de 1.5g de la coquille d’escargot donne un rendement d’adsorption du colorant MV2B de 91.96 %, et pour le MG donne un rendement de 95.72%.

Quels sont les effets de la dégradation des colorants?

La dégradation des colorants sous l’action des microorganismes produit des nitrates et des phosphates dans le milieu naturel. Ces ions minéraux introduits en quantité trop importante peuvent devenir toxiques pour la vie piscicole et altérer la production d’eau potable.

Comment a évolué l’industrie des colorants?

L’évolution de l’industrie des colorants a été étroitement liée à la découverte de la mauvéine (aniline, colorant basique) par William Henry Perlin en 1856 et la fuchsine par Verguin en 1858.Les colorants ont été appliqués quotidiennement pour la peinture et la teinture du papier et du vêtement [20].

Quels sont les trois modèles d’adsorption des deux colorants sur la coquille d’escargot?

Tableau 9 :Principaux paramètres caractérisant les trois modèles d’adsorption des deux colorants MV2B et MG sur la coquille d’escargot. Partie expérimentale Résultats et Discussions 62 7. Etude de l’isotherme d’adsorption

Tous droits r€serv€s Revue des sciences de l'eau, 1997 This document is protected by copyright law. Use of the services of 'rudit (including reproduction) is subject to its terms and conditions, which can be viewed online. This article is disseminated and preserved by 'rudit. 'rudit is a non-profit inter-university consortium of the Universit€ de Montr€al, promote and disseminate research.

https://www.erudit.org/en/Document generated on 09/22/2023 8:05 p.m.Revue des sciences de l'eauJournal of Water Science

textile par la bentonite et des sels d'aluminiumDye abatement in textile industry wastewater with bentoniteand aluminum salts

S. Kacha, M. S. Ouali and S. Elmaleh

Volume 10, Number 2, 1997URI: https://id.erudit.org/iderudit/705279arDOI: https://doi.org/10.7202/705279arSee table of contentsPublisher(s)Universit€ du Qu€bec - INRS-Eau, Terre et Environnement (INRS-ETE)ISSN0992-7158 (print)1718-8598 (digital)Explore this journalCite this article

Kacha, S., Ouali, M. S. & Elmaleh, S. (1997). 'limination des colorants des eaux r€siduaires de l'industrie textile par la bentonite et des sels d'aluminium. Revue des sciences de l'eau / Journal of Water Science 10 (2), 233"248. https://doi.org/10.7202/705279ar

Article abstract

The textile industry uses synthetic dyes, most of them being toxic. In Algeria, the agricultural reuse of

treated wastewater, even of industrial origin, is becoming commonplace. It is therefore compulsory

to drastically reduce pollutant fluxes. The presently operated conventional processes cannot meet the

water quality requirements: bioelimination of dyes is negligible and flocculation with iron salts, as

currently carried out in the SOITEX plant located in Tlemcen, Algeria, is not effective enough. The use

of aluminum salts in the flocculation of such wastewaters is well known (FIESSINGER AND

BERSILLON, 1977; LAHAV

et al. , 1978) but the resulting microflocs are not easily settleable. Bentonite, locally available at a low cost, can also eliminate micropollutants (LAHAV et al. , 1978). Associated with polyhydroxyaluminum, it can reduce such compounds as benzene or toluene, favoring

simultaneously the liquid-solids separation. This paper evaluates the treatability of dyes by bentonite

associated with aluminum salts. All the runs were carried out in a 200 cm3 batch reactor, mechanically stirred and thermoregulated at 20...C. The main physico-chemical characteristics of the bentonite are given in Table 1. The flocculant was aluminum chloride, previously neutralized with sodium hydroxide (mass ratio OH-/Al=1.85). The solutions were used immediately or left to polymerize during 6 days leading to polyhydroxyaluminum PHAl (LAHAV et al. , 1978). When the reactor was operated with bentonite and aluminum, the mass ratio Al/bentonite was maintained at 53.10-3 (KACHA, 1994). Four dyes belonging to two main families were tested: Supranol Yellow 4GL and Nylomine Green (acid dyes) and Foron Red RDGL and Foron Violet S3RL (dispersive dyes). Their concentrations were obtained by spectrophotometry. Bentonite alone does not induce a significant abatement excepted for low pH values around 4 (Figs. 1 and 2). Dye elimination appears to require a previous protonation step followed by cation exchange. The equilibrium can be modeled by a Freundlich equation (Fig. 3 and Table 2). The dyes can also be eliminated by aluminum salts alone (Fig. 4). The efficiency is then better with polyhydroxyaluminum, i.e. more than 90 % of the initial concentration is removed. Nevertheless, the dyes abatement probably results from an adsorption or chemical reaction on microflocs which are not easily settleable. By assuming that all the aluminum ions are precipitated as aluminum hydroxide, the equilibrium is modeled by the Langmuir equation which would indicate a monolayer adsorption (Fig.

5). When the reactor is operated with bentonite and aluminum salts, dye abatement is nearly

complete and the liquid-solids separation is particularly efficient (Figs. 6 and 7). The best results are

obtained with PHAl but the use of the monomer can be sufficient. The required concentrations are relatively low and the process is then economically feasible (Table 3). However, the experimental data can no longer be modeled by the Freundlich equation nor by the Langmuir equation. When the aluminum salts react alone with the dyes, the conductance displayed against the aluminum

concentration shows two straight lines of different slopes (Fig. 8). The abscissa of the points where the

slopes change are proportional to the initial dye concentration, suggesting a chemical reaction

between the dye and the aluminum salts (Fig. 9). However, the final pH value lies at the limit value of

aluminum hydroxide precipitation; an adsorption on aluminum hydroxide or an aluminum salt precipitation cannot then be assumed. In presence of bentonite, such changes of slope are not

observed and, moreover, the final pH value does not correspond either to a precipitation value (Figs.

11 and 12). At this stage, a comprehensive mechanism cannot thus be proposed.

However, the process using bentonite/PHAl is particularly efficient and easy to operate (Fig. 13 and Table 3). The results were confirmed with a true industrial effluent, the Chemical Oxygen Demand (COD) of which was reduced from 770 mg/l to less than 30 mg/l (Fig. 14). As a matter of comparison, the actual process, which includes an activated sludge treatment followed by an iron sulfate/lime flocculation, leads to an effluent containing only 140 mgCOD/l. REVUE DES SCIENCES DE L'EAU, Rev. Sci. Eau 2(1997)233-248

Éliminatio

n de s colorant s de s eau x residuaire s de l'industrie textile par la bentonite et des sels d'aluminium Dy e abatemen t o f textil e industr y wastewate r with bentonite and alumininium salts S

KACHA1, M.S. OUALI2 et S. ELMALEH3

Reç

u l e 9 octobr e 1996
accept l e 1 4 mar s 1997*

SUMMAR

Y Th e textil e industr y use s synthesi s dyes mos t o f the m bein g toxic I n

Algeria

th e agricultura l reutilizatio n o f treate d wastewater eve n industrial i s beeo min g a stron g requirement I t i s therefor e compulsor y t o drasticall y reduc e th e pollutant s fluxes. A s a matte r o f fact th e actuall y operate d conventiona l pro cesse s canno t mee t th e qualît y requirements th e dye s bioeliminatio n i s negtigi bl e an d th e fiocculation wit h iro n salt s a s currentl y carrie d o n i n th e SOITE X plan t locate d i n

Tlemcen

Algeria

i s no t effectiv e enough Th e us e o f alumi niu m salt s i n th e fiocculation o f suc h wastewater s i s wel l know n (FIESS1NGE R an d

BERSlLLON

1977
; LAHAV et al, 1978). Nevertheless, the resulting micro- floc s ar e no t easil y settleable

Bentonite

locall y availabl e a t a lo w cost ca n als o eliminat e micropollutant s (LAHAV et al, 1978). Associated with polyhydroxya- luminium i t ca n abat e suc h compound s a s benzèn e o r toluène favourin g simultaneousl y th e liquid-solid s séparation Thi s pape r

évaluâte

s th equotesdbs_dbs27.pdfusesText_33
[PDF] principe de l électrocoagulation

[PDF] traitement des eaux usées par electrocoagulation memoire-

[PDF] principe de coagulation floculation

[PDF] adsorption de bleu de methylene sur largile

[PDF] adsorption des colorants sur les argiles

[PDF] traitement des eaux usées par coagulation floculation pdf

[PDF] elimination des métaux lourds par adsorption

[PDF] french vocabulary with pictures pdf

[PDF] phrasal verbs english french pdf

[PDF] basic french vocabulary list

[PDF] complete french grammar pdf

[PDF] american english vocabulary pdf

[PDF] english vocabulary list with french translation

[PDF] oxford english french dictionary pdf

[PDF] la formation des adverbes en ment