[PDF] Command Line Interface (CLI) Guide - Dell PDF powerconnect-3424_reference%20guide

This appendix describes how to recover a password that you configured with the From user EXEC mode, display the existing configuration register value: Note To enable break, enter the config-register 0x01 global configuration command

[PDF] Configuring Security with Passwords, Privileges, and Logins - Cisco

The default configuration of a Cisco IOS software-based networking device allows you to configure passwords to protect access only to user EXEC mode (for

[PDF] Lab 526a Password Recovery Procedures – Instructor Version 2500

Step 7 Enter Privileged EXEC mode and change password a Now at the user mode prompt Router>, type enable and press Enter to go to the privileged

[PDF] Getting Started with AlliedWare Plus Feature - Allied Telesis

03:17:10 awplus Password change is strongly recommended 03:17:22 To change from User Exec to Privileged Exec mode, enter the command: awplus>

[PDF] Lab – Researching Password Recovery Procedures (Instructor

When booted, the user will access privilege EXEC mode, overwrite the running configuration with the saved startup configuration, recover or reset the password,

[PDF] Password recovery procedure for Layer 2 and Layer 3 switches

prompt will return to the Privileged EXEC mode (#) The admin and enable password are now both reset to default (no password) Setting the Admin and Enable

[PDF] Lab – Configuring Basic Switch Settings (Solution)

the VLAN 1 SVI is assigned an IP address, by default all ports in VLAN 1 have access to the You can access all the switch IOS commands in privileged EXEC mode should be restricted by password protection to prevent unauthorized use