[PDF] Module 4: Inter-VLAN Routing PDF SRWE_Module

Configure inter-VLAN routing using Layer 3 switching Troubleshoot There is no need for external links from the switch to the router for routing • They are not

peuvent également être appliqués à d'autres commutateurs de la couche 3 qui Activez le routage sur le commutateur avec la commande ip routing voulez router un trafic entre les VLAN 2, 3 et 10 2 Switch(config-if)#no shutdown

[PDF] Configuring Layer 3 Interfaces - Cisco

A traditional network requires a physical interface from a router to a switch to perform inter-VLAN routing The Catalyst 4500 series switch supports inter-VLAN

[PDF] Chapter 4: Implementing Inter-VLAN Routing

Switch(config)# router ip routing protocol options Layer 3 interface Switch( config-if)# no switchport ▫ Step 3 Configure the IP address and IP subnet mask

[PDF] Chapter 5: Inter-VLAN Routing

environment ▫ Configure inter-VLAN routing using Layer 3 switching Layer 2 switches cannot forward traffic between VLANs without the assistance of a router Each VLAN was connected to a different physical router interface ▫ Packets

[PDF] :::::::notes:::::: InterVLAN (Routing between VLANs) (Layer 2 Vs

Router on a stick (layer 2 switch trunks traffic to external layer 3 router)(legacy no stp convergence issue and moreover only if the design specifies that the S( config)#ip routing (to turn on layer 3 switching/on a router this command is by

[PDF] Inter VLAN Routing

Introducing Routing and Switching in the Enterprise – Chapter 5 Copyleft 2012 Any device that supports Layer 3 routing, such as a router or a multilayer On the router, configure a FastEthernet interface with no IP address or subnet mask