INSTALLATION INSTRUCTIONS PROGRAMMER CABLE FOR SLC 5/03 & 5

The most common serial communication protocols are RS232, RS485, RS422, USB, and Ethernet But because USB and Ethernet require powerful interfaces with complex protocols, many efficient devices utilized RS232, RS485, and RS422 which is what this note is all about Protocol Comparison Chart RS-232 RS-422 RS-485 Cable Single ended

1770-56, DeviceNet RS-232 Interface Module Installation

Connect the 1770-KFD module to a computer by using the RS-232 cable RS232 cable to host computer retentive locking screws 20295b IMPORTANT: If you build your own RS232 cable, it must not be longer than 10M/32 8’

RS-232C COMMUNICATION PROCEDURE (Fanuc-0i)

Note: Plug in the RS-232C cable at PC end as well as CNC system end after switching off the power Receiving the program from machine to PC Now, the receiving end is the PC On the PC, • Double click on the machine & select Receive program from the menu that appears • In the dialog box that appears, enter From machine as the file name in

Modbus Serial Cabling Addendum

RS232 cabling is point to point The cable pin-out is specific to the requirements of the External Device The Pro-face hardware requires a minimum of 3 conductors and a jumper: Send Data (SD), Receive Data (RD), a Common (SG), and a jumper between the RS and CS The cable pin-out and jumpers required by the connected External Device should be

TTL-232R TTL to USB Serial Converter Range of Cables Datasheet

The USB side of the cable is USB powered and USB 2 0 full speed compatible Each cable is 1 8m long and supports a data transfer rate up to 3 Mbaud Each cable supports the FTDIChip-ID™, with a unique USB serial number programmed into the FT232R This feature can be used to create a security or