Xerox VersaLink C405 Guidedel’utilisateur-Imprimante

If the impression is stored under water, imbibition (uptake of water) occurs which results in swelling of the impression Either will cause unacceptable distortion in the final cast o It is optimal to pour an impression within 10-15 min after it has been made Even during that period, the impression must be wrapped in a damp paper towel

PROSTHETIC REPAIR IMPRESSION GUIDE - Prodenco

2 After proper setting time, remove the impression keeping the partial in the impression 3 Pour immediately or send it to Prodenco according to material instructions 4 If you have the clasp, send it along with the partial still in the impression Partial Denture Refit Take an impression with-out the partial in place, send the impression or

Removable Prosthetic Repair Impression Guide

1 Take an alginate impression with the partial in place and remove impression from the mouth, keeping the partial in the impression 2 Pour immediately or send it to Dental Prosthetic Services along with the opposing arch, bite registration, and shade if necessary Soft Seal Gasket Replacement 1 Remove the old silicone gasket material 2

PDF LOW RES AVEC COUVERT FINAL POUR IMPRESSION 11-11-21 09

avec couvert final_pour impression 11-11-21 09:51 page1 Second, considering the vital need to exchange information, we have included extended networking time to help foster cooperation and establish new connections

Consommables certifiés Zebra : rubans pour impression thermique

Rubans pour impression thermique Les rubans pour impression thermique ne sont pas tous conçus de la même façon Fort de son savoir-faire et de son expérience des rubans et des technologies correspondantes, Zebra vous propose les rubans les mieux adaptés à vos applications, pour que votre imprimante fonctionne de façon optimale

Alginates Guideline for taking perfect situation impressions

5 5 Assessing and preparing the impression 12 6 Model fabrication 14 6 1 Required materials 14 6 2 Preparing the impression 15 6 3 Mixing the dental gypsum 15 6 4 Pouring the impression 16 6 5 Removing the impression from the model 16 6 6 Trimming the model 17 7 References 17 8 Troubleshooting 18 3