Space Shuttle Ascent: Altitude vs Time - NASA
The space shuttle experiences changes in altitude, velocity, and acceleration during the ascent into space These changes can be seen by taking a closer look at the entire ascent process (Figure 3)
ALTITUDE™ X 42 DIRECT VENT GAS FIREPLACE
ALTITUDE™ X 42 DIRECT VENT GAS FIREPLACE W415-1933 / A / 01 15 20 Specifi cations Model BTU Width Height Depth Glass Size Actual Framing Actual Framing Actual Framing AX42NTE 38,000 42 1/4 42 3/4 45 7/16 46 5/8 18 5/8 19 28 3/4 x 37 11/16 AX42PTE 36,500 Dimensions Appliance Location Do not put objects in front of the appliance (minimum
ALTITUDE™ X 36 DIRECT VENT GAS FIREPLACE
ALTITUDE™ X 36 DIRECT VENT GAS FIREPLACE W415-1931 / A / 01 15 20 Specifi cations Model BTU Width Height Depth Glass Size Actual Framing Actual Framing Actual Framing AX36NTE 36,500 35 1/4 35 3/4 42 7/16 43 5/8 18 3/4 19 25 3/4 x 30 11/16 AX36PTE 35,000 Dimensions Appliance Location Do not put objects in front of the appliance (minimum
Pulse Oximetry at High Altitude - AMGA
Feb 05, 2011 · Clinician’s corner: pulse oximetry at high altitude High Alt Med Biol 12:109–119, 2011 —Pulse oximetry is a valuable, noninvasive, diagnostic tool for the evaluation of ill individuals at high altitude and is also being increasingly used to monitor the well-being of individuals traveling on high altitude expeditions
INSTALLATION MANUAL ALTITUDE ARMS AND CANOPY
The Altitude Awning is a product of Carefree of Colorado, located in Broomfield, Colorado, USA The information contained in or disclosed in this document is considered proprietary to Carefree of Colorado Every effort has been made to ensure that the information presented in the document is accurate and complete
SERVICE MANUAL ALTITUDE - Carefree of Colorado
The Altitude Patio Awning is a product of Carefree of Colorado, located in Broomfield, Colorado, USA The information contained in or disclosed in this document is considered proprietary to Carefree of Colorado Every effort has been made to ensure that the information presented in the document is accurate and complete
USA SWIMMING ALTITUDE ADJUSTMENTS
USA SWIMMING ALTITUDE ADJUSTMENTS (as of January 2013) NOTE: The following is from the USA Swimming Policy Manual posted at www usaswimming as of January 2013 14 USA SWIMMING SWIMS TIMES MODULE – POLICY AND GUIDELINES 4 6 ALTITUDE ADJUSTED TIMES A Information on Altitude Adjusted Times May be Found in the USA Swimming Policy Manual
Altitude Pressure Chart - ITT Aerospace
Altitude Pressure Chart Aerospace Controls-2000-1000 0 1000 2000 3000 4000 5000 6000 7000 8000 9000 10000 11000 12000 13000 14000 15000 16000 17000 18000 19000 20000 21000 22000 23000 24000 25000 26000 27000 28000 29000 30000 31000 32000 33000 34000 35000 32 15 31 02 29 92 28 86 27 82 26 82 25 84 24 90 23 98 23 09 22 23 21 39 20 58 19 80 19 03
[PDF] calculer l'angle de réflexion totale
[PDF] angle de refraction definition
[PDF] calculer l'angle d'incidence limite
[PDF] touche sin-1 calculatrice
[PDF] comment calculer l'angle limite de refraction
[PDF] fonction linéaire antécédent
[PDF] calculer la hauteur d'un parallélépipède rectangle
[PDF] exercice patron d'une pyramide
[PDF] abc est un triangle rectangle en a et h est le pied de la hauteur issue de a calculer sin abc
[PDF] demande parfaitement élastique exemple
[PDF] élasticité microéconomie
[PDF] coefficient d'élasticité mercatique
[PDF] elasticité de la demande par rapport au prix def
[PDF] élasticité de la demande par rapport au prix définition
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada ? 1(866)820-8686 ? www.napoleon.com
34 13/16"
884mm33 1/8"
842mm1 13/16"
46mm18 3/4"
476mm42 7/16"
1078mm
7 15/16"
201mmGAS INLET 8" 203mm
5" 127mm
11 13/16"
300mm10 1/2"
267mm35 1/4"
896mmFRONT VIEW RIGHT SIDE VIEW TOP VIEW
ALTITUDE™ X 36 DIRECT VENT GAS FIREPLACE
W415-1931 / A / 01.15.20
Specifi cations
Model BTUWidth Height DepthGlass SizeActual Framing Actual Framing Actual Framing AX36NTE 36,50035 1/4 35 3/4 42 7/16 43 5/8 18 3/4 19 25 3/4 x 30 11/16AX36PTE 35,000Dimensions
Appliance Location
Do not put objects in front of the appliance
(minimum distance of 4 feet)*SIDE WALL12"(30.5cm)
Combustible Mantel Clearances
MLKJTOP OF
FIREPLACE
OPENING
MANTEL DIMENSIONS
Ref Height Depth*
J10" (254mm) 2" (51mm)
K12" (305mm) 4" (102mm)
L14" (356mm) 6" (152mm)
M16" (406mm) 8" (203mm)
52 3/8"
(132.9cm)37"(93.9cm)
35 3/4"(90.8cm)
19" (48,2cm)** Finishing flange (the finishing flange defines the perimeter of the fireplace opening. Framing or finishing materials must NEVER encroach inside the finishing flange).
*Mantel depth must be appropriately sized if placing any valuable items above the fi replace / mantel (see installation manual).Mantel clearances may be reduced ONLY if
the Altitude™ X Heat Management System is installed (see installation manual).Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada ? 1(866)820-8686 ? www.napoleon.com
ALTITUDE™ X 36 DIRECT VENT GAS FIREPLACE
Product information provided is not complete and is subject to change without notice. Please consult the installation manual for
the most up to date installation information.W415-1931 / A / 01.15.20
Wall Penetration
Firestop
assemblyNon-combustible
material1" [25mm]0 [0mm] if non-combustible
finishing material is used such as brick and stone.Insulated
sleeve3" [76mm] to top 2" [51mm] to sides / bottomNon-combustible
BrickCombustible
1" [25mm] minimum all sides for vertical venting sections.
When passing through a ceiling, use firestop
W500-0028 (not supplied).
3" min. 12" [30.5cm]72 (182.8cm)
min. for typical application84 (213cm) min.
for recess application54 7/8"(139.3cm)plus rise
34 13/16"(88.4cm)
Vent Sections
When passing through a wall, use
fi restop spacer W010-1800 (supplied).When passing through a ceiling,
use fi restop spacer W500-0028 (not supplied). note:Horizontal vent sections: A minimum
clearance of 3" (76mm) on the top of the vent to combustibles and 2" (51mm) on the sides and bottom of the vent to combus- tibles is required.Vertical vent sections: A minimum clear-
ance of 1" (25mm) all around the vent pipe on all vertical runs to combustibles is required.Flush FramingRecess Framing
Flush & Recessed Framing
72"(182.8cm) min.
43 5/8"
(111cm)* 84"(213cm) min.
43 5/8"
(111cm)*3 1/2"
(88.9mm) **Combustible header
* Allow for finished floor and hearth thickness when setting these dimensions. ** 2" x 4" frame can be backed" with 3/4" ply to support TV mounting hardware.Combustible header
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada ? 1(866)820-8686 ? www.napoleon.com
L"information du produit fourni n"est pas complet et est sujet de changer sans préavis. Consultez le manuel d"installation pour
information d"installation actuel.W415-1931 / A / 01.15.20
Pénétration du Mur
Assemblage
deCoupe-Feu
Matérial
Incombustible
1" [25mm]0 [0mm] si les matériaux
de finition incombustible sont utilisés comme la brique ou la roche. 72"[182,8cm] hauteur de l'enceinte / plafond
Manche
Isolé3"
[76mm]à Dessus
2" [51mm] aux côtés / au basIncombustible
BriqueCombustible
1" [25mm] minimum chaque côtés pour l'évacuation
verticale hors du plafond de l'enceinte. Lorsque du passage à travers un plafond, utilisez le coupe-feu W500-0028 (non fourni).7 1/2"
[191mm]1½" [38mm] minimum chaque côtés pour
l'évacuation verticale hors de l'encinte. 12" [30,5cm]54 7/8"(139.3cm)plus la pente
34 13/16"(88.4cm)
Sections d"Évents
Lors du passage à travers un mur,
utilisez l"espaceur coupe-feu W010-1800 (fourni). Lors du passage à
travers un plafond, utilisez l"espaceur coupe-feu W500-0028 (non fourni). note:Sections d"évents horizontale: Un
dégagement minimum aux matériaux combustibles de 3" (76mm) au-dessus et 2" (51mm) sur les côtés et au-des- sous est requis.Sections d"évents verticale: Un
dégagement minimum aux matériaux combustibles de 1" (25mm) est requis toute autour du conduit d"évacuation sur toutes les courses verticale.72"(182.8cm)hauteur de la enceinte / plafond
Encadrement Affl euré Encadrement Encastré
Encadrement Affl euré et Encastré
FOYER À GAZ VENTILÉ DIRECTE ALTITUDE
MD X 36 72"(182.8cm) min. 84"
(213cm) min.
43 5/8"
(111cm)*3 1/2"
(88.9mm) **43 5/8"
(111cm)*Linteau combustible
Linteau combustible
* Tenez compte de l"épaisseur du plancher et du foyer lorsque vous définissez ces dimensions.** Le cadre de 2 "x 4" peut être " renforcé » avec une pièce contreplaqué d"un épaisseur de 3/4po pour supporter le matériel de montage du téléviseur.
quotesdbs_dbs9.pdfusesText_15