[PDF] DALI SUB E-12 F MANUAL

DALI-2: The latest version of the DALI protocol

The DALI protocol was first drafted in the late 1990s and has undergone a number of revisions as it has evolved The result is DALI-2, the latest version o f the DALI protocol, which is specifie d in the DALI standard IEC 62386

Quick Installation and Operation with DALI Guide

To additional DALI devices DALI Bus Wiring (See page 5 for complete wiring specification) Two 1,5 mm 2 (16 AWG) each terminal DALI devices: ballasts, drivers, or interfaces Two D1 and two D2 connections are provided for ease of wiring, and to provide two connecting points; there is only one DALI link on the unit Note: Ballasts and

Atmel AT01244: DALI Slave Reference Design

DALI (Digital Addressable Lighting Interface) is an international standard created for lighting control and now becomes one of the more popular lighting interfaces today DALI protocol is a digital communication interface with master-slave structure, aiming as a control gear between power supply and LED

Using DALI in HWQS - Lutron Electronics Company Inc

Using DALI Ballasts in HWQS – Rev A Page 4 DIN-rail Power Module (DPM) w/ DALI The DIN-rail Power Module w/ DALI is a QS wired device that resides on the QS link and counts

DALI SUB E-12 F MANUAL

DALI SuB E-12F features a front-firing woofer, a down-firing bass port and, at the rear side of the subwoofer, an amplifier metal plate which can become hot when the subwoofer is powered Make sure that the woofer and the bass port are not blocked or covered

DALI Power Module SPEC (369650)

DALI ® Power Module The DALI ® Power Module is a DIN-rail mounted controller for DALI ®-compliant digital addressable loads, referred to as control gear It provides DALI ® bus power and control for two independent DALI ® buses with up to 64 DALI-compliant digital addressable loads each Model Number LQSE-2DAL-D: 2-link DALI ® fixture

Atmel AT06409: DALI Master with ATxmega32E5 User Guide

The DALI bus signal are differential signal, the DALI bus power supply cannot share the same ground with the USB input power supply Table 3-3 Polarity of DALI Bus Power Supply Pin of DALI bus power supply socket Polarity 1 16 V+ or 16V- 2 16 V- or 16V+ In this kit, the on board DALI bus power supply is designed support upto 16 DALI Slaves

[PDF] sujet cap froid et climatisation 2016

[PDF] sujet cap electricien 2013

[PDF] sujet cap froid et climatisation 2013

[PDF] sujet cap electricien batiment

[PDF] froid climatisation pdf

[PDF] exercices corrigés de froid et climatisation

[PDF] exercices corrigés froid industriel

[PDF] exercice corrigé machine frigorifique pdf

[PDF] protection des données personnelles cnil

[PDF] confidentialité des données personnelles

[PDF] durée de conservation des données personnelles cnil

[PDF] comment sécuriser les données informatiques

[PDF] manifestation de la guerre froide en europe

[PDF] les causes de la coexistence pacifique

[PDF] guerre froide:causes et consequences

DALI SUB E-12 F

MANUAL

ENGLISH - DEUTSCH - DANSK - ᪥ᮏ

DAL

I SUB E-9 F

MANUAL

ENGLISH - DEUTSCH - DANSK

DALI SUB E-12F

Speaker(s)

pr. carton

2TABLE 1

FIGURE 1FIGURE 2

3FIGURE 3

LINE INPUTLFE

P/N: 360137-0-0FOR INDOOR USE ONLY

CAUTION

WARNING: SHOCK HAZARD-DO NOT OPEN

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

DALI A/S, Dali Allé 1, DK-9610 Nørager, Denmark | Designed and engineered in Denmark by DALI A/S

POWER ONOFF

220-240V~ 250W 50/60Hz

RISK OF FIRE REPLACE FUSE AS MARKED

1.6AL/250V, 230V~

Danish Audiophile Loudspeaker Industries

VOLUMECROSSOVER

MINMAX40Hz120Hz

PHASE OFFON

POWER MODE

80Hz
AUTO 180

CAUTION

DISCONNECT SUPPLY CORD BEFORE REPLACING FUSE.

FOR CONTINUED PROTECTION AGAINST RISK OF FIRE

REPLACE ONLY WITH SAME TYPE FUSE.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

BAED

UKDEDKJP

CONTENTS / INHALT / INDHOLD

ENGLISH

DANSK

CAUTION

RISK OF ELE

SHO

K DO NO

OPEN. O RED

E THE RISK OF ELECTRIC SHOCK,

DO NO

REMOVE THE BACK PANEL.

SER-SERVI

EABLE PARTS INSIDE.

REFER SERVI

ING TO QUALIFIED PERSONNEL.

he lightning fiash within an equilateral triangle is intended to alert you to the presence of non insulated “dangerous voltage" within the product"s enclosure that may be of sufcient magnitude to constitute an electric shock to persons. he exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Read instructions - all the safety and operating instructions should be read before the appliance is operated. Retain instructions - the safety and operating instructions should be retained for future reference. Heed warnings - all warnings on the appliance and in the operating instructions should be adhered to. Follow instructions - all operating and use instructions should be followed. Water and moisture - the appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool and the like. Carts and stands - the appliance should be used only with a cart or stand if recommended by the manufacturer. Wall or ceiling mounting - the appliance should be mounted to a wall or ceiling only as recommended by the manufacturer.

Ventilation - the appliance should be situated so that its location or position does not interfere with proper ventilation.

For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet, that may impede the fiow of air through the ventilation openings. Heat - the appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.

Power sources - the appliance should be connected to a power supply only of the type described in the operating

instructions or as marked on the appliance.11 Power cord protection - power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs, convenience receptacles and the point where they exit from appliance. Appliance coupler serves as disconnecting device. Cleaning - do not use any liquid cleaners. Use only a dry cloth to wipe off dust and grease. Non-use periods - the power cord of the appliance should be unplugged from the outlet when left unused for a long period of time.

Object and liquid entry - care should be taken so that objects do not fall and liquids are not spilled into the

enclosure through openings. Damage requiring service - the appliance should be serviced by qualied personnel when: The power-supply cord or the plug has been damaged; or Objects have fallen, or liquid has been spilled into the appliance; or

The appliance has been exposed to rain; or

The appliance does not appear to operate normally, or exhibits a marked change in performance; or

The appliance has been dropped, or the enclosure

damaged. Servicing - the user should not attempt to service the appliance beyond that described in the opera ting instructions. All other servicing should be referred to qualied service personnel.

UKDEDKJP

CONTENTS

1.0 IN

ROD UCT ION 2.0 NPA KING

3.0 POSI

IONING

4.0 ONNE ION

5.0 INS

TALLING AND ADJUSTING 10

6.0 RUNNING-IN 12

7.0 OVERLOADING

8.0 MAIN

ENAN

9.0 DISPOSAL

10.0 AMPLIFIER BA

K PLATE (SEE FIGURE 3) 13

11.0 TECHNICAL SPECIFICATIONS 13

81.0 INTRODUCTION

ongratulations on your new DALI S B E-12F subwoofer. Please read this manual thoroughly before unpacking and installing the subwoofer in order to get the most f rom your purchase. You can nd more information on our website: www.dali-speakers.com or by contacting your authorised DALI dealer. Remember to sign up for the DALI newsletter at www.dali-speakers.com.

Enjoy!

2.0 UNPACKING

Be careful not to damage the contents when unpacking the parts. heck that all parts are included in the cardboard box (see Table 1). Keep the packaging materials in case your speaker needs to be relocated or serviced.

3.0 POSITIONING

Both the amount and quality of the deep bass depend on the size and shape of the room, the position of the subwoofer(s) and the main speakers. If positioned near a side or back wall, the bass will be accentuated. A corner position will accentuate it even more, and we recommend this position, as it increases the maximum bass output while simultaneously reducing the risk of overloading your subwoofer.quotesdbs_dbs2.pdfusesText_4