2018 - Engine & Fuel Heating, Idle Free Systems, EV Charging

Take care that the core plug does not drop inside the engine block Using pliers, grasp the plug firmly and remove it Clean the machined part of hole; remove burrs, com-pound, paint, rough spots or sharp outer edges Apply a coating of lubricant to the surface of hole and the “O” ring on the block heater Insert block heater as shown

DODGE RAM, DURANGO, MAGNUM/CHRYSLER 300N—5

DODGE RAM, DURANGO, MAGNUM/CHRYSLER 300N—5 7L Engine Block Heater 07-17-2003 1 of 4 K6858664 C D A B 6x NOTE TO INSTALLER: Kit parts shown can be installed on Dodge Ram (page 2), Dodge Durango (page 3), and Dodge Magnum/Chrysler 300N (page 4)

CARQUEST Engine Heater Application Guide

• Air not bled from system (run engine until maximum system pressure is reached before plugging it in) • Plugged in before it is installed to see if it gets hot (trust us IT WILL) • Tank style heater installed in the wrong physical location • Tank style heater not connected to the right locations LOCATION OF BLOCK HEATER

CHRYSLER 36 PENTASTAR 2012-2015 COOLING SYSTEMS

Run the engine with the radiator cap installed, so that the system builds pressure Holding the engine at 3000rpm for 2-3 minutes may help, or a short drive (less than a mile) with the heater still set to full heat may help move the air to the radiator so it can be purged At this point it is likely the coolant will be boiling in the engine block

Application Guide & Product Catalog ‘08

NEW PRODUCT LIST: ENGINE HEATERS 3100108 Engine heater, 400w, 120w, 35mm 3100109 Engine heater 400w, 120v, 23mm, includes cord with thermostat, GM

Application Guide & Product Catalog - Engine & Fuel Heating

• Visual cue to indicate power to the block heater • Harnesses may be purchased to upgrade existing block heater kits • CSA approved See page 93 for additional product details and page 6-36 for model spcific applications • Provides heat to the filter core, prior to start of engine to prevent filter clogging

CHRVSLER - National Highway Traffic Safety Administration

Safety Recall H21 - Engine Wiring Harness Routing Page 6 Service Procedure [Continued] 10 Reposition the main wiring harness and, if equipped, the engine block heater cord Secure them using a tie strap as shown in Figure 4 11 Verify that the main wiring harness and, if equipped, the engine block heater

2007 CHRYSLER PACIFICA - THE SAFETY UTILITY VEHICLE

Engine Block Heater OOOOOOOO Speed Control — Electronic with steering wheel-mounted controls SSSSSSSS Suspension — Independent, performance-tuned; front, MacPherson; rear, 5-link, load-leveling SSSSSSSS