5 fév 2015 · Intercryl 530 should always be applied over a recommended anti-corrosive following documents available at www international-pc com:
2 avr 2015 · Apply one or more coats of Intercryl 530 as specified on our website at www international-marine com or www international-pc com
¹ Voir section Définitions et Abréviations du manuel International Protective Coatings L'Intercryl 530 doit toujours être appliqué par-dessus un type de
Intercryl 520 Intercryl 530 For other suitable primers/topcoats consult International Protective Coatings SYSTEMS COMPATIBILITY Page 3 of 4
¹ Consulte as Definições e Abreviaturas da International Protective Coatings nos seguintes documentos disponíveis em www international-pc com:
¹ Voir section Définitions et Abréviations de International Protective Coatings Intercryl 530 Intergard 740 www international-pc com Page 4 of 4
Lorsqu'une finition esthétique est nécessaire les produits suivants sont recommandés: • Intercryl 530 • Interfine 878 • Intergard 740 • Interthane 990
Where a cosmetically acceptable topcoat is required the following products are recommended: • Intercryl 530 • Interfine 878 • Intergard 740 • Interthane 990
¹ See International Protective Coatings Definitions and Abbreviations Intercryl 530 Intergard 475 Intercure 200 www international-pc com
existing convertible coatings: Intergard 251 Intergard 269 The following topcoats are recommended for Interprime 198: Intercryl 530 Interfine 629HS
Feb 5 2015 · Intercryl 530 should always be applied over a recommended anti-corrosive coating scheme The primer surface should be dry and free from all contamination and Intercryl 530 must be applied within the overcoating intervals specified (consult the relevant product data sheet)
Feb 5 2015 · Although Intercryl 525 is slightly thermoplastic above 50°C (120°F) the polymer system is stable to continuous temperatures of 150°C (300°F) with intermittent temperatures of 200°C (390°F) Intercryl 525 must be fully cured before exposing to ponding water otherwise adhesion loss can occur
Feb 4 2015 · apply one or more coats of Intercryl 530 as specified Consult the relevant primer data sheet for specific surface preparation and overcoating information Check integrity of existing coating system and apply a representative test patch to confirm compatibility Consult your International Paint representative for procedures Page 2 of 4 Ref:23
Prepare surface and apply recommended primer. Apply one or more coats of Intercryl 530 as specified. (Consult the relevant primer data sheet for surface preparation and overcoating information.) Remove all mill scale, loose rust, loose paint and other foreign matter by "Hand or Power Tool Cleaning" (SSPC-SP2 or SP3, respectively).
A one component heavy duty, high build water borne acrylic emulsion which provides excellent pliability and elasticity, allowing appreciable substrate movement without cracking. Intercryl 428 has been designed to give excellent resistance to gas diffusion and water vapour transmission. A heavy duty water borne acrylic coating.
It is also the preferred coating for sprayed polyurethane foam and is a long life finish coat over Intergard 436 on fibre cement roofing. Intercryl 988 has high volume solids, exhibits long term resistance to UV and atmospheric pollution and remains permanently flexible and elastic.