Specification Sheet G11-448 Rev 9

[PDF] seiko 4r35 avis

[PDF] seiko 5 4r36

[PDF] seiko automatic 4r35

[PDF] seiko premier automatic 4r39

[PDF] reglage montre seiko automatique

[PDF] rgph 1998 côte d'ivoire

[PDF] fonctionnement seiko solar

[PDF] résultats rgph 2014 maroc

[PDF] montre solaire seiko avis

[PDF] comment regler une montre electronique

[PDF] démographie côte d'ivoire

[PDF] comment regler une montre automatique

[PDF] reglage seiko 5

[PDF] pyramide des ages de la population ivoirienne en 1

[PDF] seiko kinetic auto relay

Specification Sheet G11-448 Rev 9 - InspectAPedia

FORM NO. G11-448 REV. 9

Supersedes Form No. G11-448 Rev. 8

GAS FURNACES

CRITERION

II80.0%-81.7% A.F.U.E.

UPFLOW/

HORIZONTAL

GAS FURNACES

The Rheem

Criterion

II line of upflow/horizontal gas fur-

naces are designed for utility rooms, closets, alcoves, or attics. Because of the Criterion's low-profile 34 inch [864 mm] height, the upflow model can also be used to satisfy most applications that traditionally call for a horizontal furnace.

The design is certified by CSA.

Features

nPatented Heat Exchanger, constructed of both stainless and aluminized steel for the maximum in corrosion resistance.

nLow profile "34 inch" design is lighter and easier to han-dle, and leaves room for optional equipment.

nConvertible from upflow to horizontal left or right withoutfield conversion. nLeft or right side gas and electric inlet connections withquick, simple change.

nDirect spark ignition models utilize remote sense and fea-ture an integrated board with humidifier and electronic aircleaner hookups.

nInsulated blower compartment helps to reduce jacket lossand noise. nPre-paint galvanized steel cabinet. nMolded permanent filter. nGrab-holes in doors to aid in easy door removal andreplacement. A variety of cooling coils and plenums designed to use with Rheem Criterion II gas furnaces are available as optional accessories. These furnaces can be installed in an upflow position or laid on either side in a horizontal position. No field converting required. =A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with Department of

Energy test procedures.

RGPH- SERIES

Models with Input Rates from50,000 to 150,000 BTU/HR[13 to 44 kW](U.S. & Canadian Models)

2Rheem Manufacturing Company

RHEEM CRITERIONII80%UPFLOW/HORIZONTALGASFURNACE

STANDARD EQUIPMENT

Completely assembled and wired; induced draft blower; pressure switch; redundant main gas control; blower compartment door safety switch; solid state time on/time off blower control; limit control; manual shut-off valve, pressure regulator for natural and L.P. (propane) gas; transformer; direct drive multi-speed blower motor. Furnaces are equipped with cooling/heating relay and transformer (40VA) ready for air conditioning applications. (Please note: a thermostat is not included as standard equipment.) Flame sensor diagnostics; on-board twinning options;fused transformer (secondary), 3rd speed fan option for continuous fan; common heat/cool terminal.

OPTIONAL EQUIPMENT

Side filter frame assembly. Return air cabinet for all sizes. (See Page 6) NOTE:Furnace is not listed for use with fuels other than natural or L.P. (propane) gas.

WARNING

THIS FURNACE IS NOT APPROVED

OR RECOMMENDED

FOR USE IN MOBILE HOMES

The complete terms of limited and other warranties are available at our sales office, or through local installer. All models can be converted by a qualified Rheem distributor or local service dealer to use L.P. (propane) gas without changing burners. Factory approved kits must be used to convert from natural to L.P. (propane) gas and may be ordered as optional accessories from a Rheem parts distributor. For L.P. (propane) operation, refer to Conversion Kit Index Form.

Direct Spark Ignitor

with Remote SenseIn-Shot BurnersDraft Inducer Motor

Integrated

Furnace

Control

Heat Exchanger

Molded

Permanent Filter

Rheem Manufacturing Company3

BEFORE PURCHASING THIS APPLIANCE, READ IMPORTANT ENERGY COST AND EFFICIENCY INFORMATION AVAILABLE

FROM YOUR RETAILER.

PHYSICAL DATA AND SPECIFICATIONSU.S. AND CANADA MODELS (UPFLOW/HORIZONTAL)

MODEL IDENTIFICATIONÑUPFLOW MODELS

[] Designates Metric Conversions

MODELNUMBERS

RGPH- SERIES05EAUER

05NAUER07EAUER

07NAUER

Standard Filter-In.

[mm]15 3 /4x 25 [400 x 635]15 3 /4x 25 [400 x 635]

Input-BTU/Hr [kW] Á50,000 [15]75,000 [22]

Heating Capacity BTU/Hr [kW] À41,000 [12]60,000 [18]

High Altitude Input [kW]*45,000 [13]67,500 [20]

Blower (D x W) [mm]

11 x 6

[279 x 152]11 x 6 [279 x 152]

Motor H.P.ÐSpeedsÐ

PSCType [W]

1 /2-4-PSC [373] 1 /2-4-PSC [373]

Motor Full Load Amps6.87.1

Heating SpeedMED-LOWMED-HIGH

Cooling SpeedHIGHHIGH

Cooling CFM @.5"[kPa] E.S.P.

(Nominal) [L/s]1200 [566]1200 [566]

Rated E.S.P. (In. W.C.) [kPa].50 [.12].50 [.12]

Temperature Rise Range ¡F

[¡C]25-55 [13.9-30.6]40-70 [22.2-38.9]

Max. Outlet Air Temp. ¡F

[¡C]155 [68.3]165 [73.8]

Approx. Shipping Weight (Lbs.)

[kg]85 [39]105 [48]

Return Air Cabinets

(Opt.) RXGR-

Filter Size [mm]C14B

(2) 12 x 16 [305 x 406]C17B (2) 12 x 16 [305 x 406]

AFUEÐElectric Ignition Models À81.4%80.6%

California Seasonal EfficiencyÐ

Electric Ignition/No

xModelsquotesdbs_dbs2.pdfusesText_2

[PDF] Specification Sheet G11-448 Rev 9 - InspectAPedia