[PDF] BAOFENG UV-5R - Multnomah County ARES PDF BAOFENG-UV-5R-MJS-2.pdf

BAOFENG UV-5R Turn ON/OFF and Adjust volume: turn knob on top INITIAL SET UP: Turn off dual monitor mode: MENU-7-MENU-0-MENU-EXIT

UV-5R Cheat Sheet txt When manually programming duplex frequencies into the UV-5R you will be first enter and save your receive frequency in a desired

[PDF] BaoFeng UV-5R Channel Programming Cheat Sheet 7/19/2018

BaoFeng UV-5R Channel Programming Cheat Sheet 7/19/2018 Key Concepts ALWAYS place the radio in “frequency mode” by toggling the orange

[PDF] BAOFENG UV-5R - Multnomah County ARES

BAOFENG UV-5R Turn ON/OFF and Adjust volume: turn knob on top INITIAL SET UP: Turn off dual monitor mode: MENU-7-MENU-0-MENU-EXIT

[PDF] Baofeng UV5R-eyes-free

2 juil 2012 · Added menu codes and moved DCS codes to a table Jim Mayes,KC5QDM All the folks on the Baofeng UV-5R Yahoogroup for hints on

[PDF] Reference for UV-5R Menus by Jim Unroe - KC9HI 13-July - Miklor

13 juil 2014 · PTT-ID (Signal-CODE) Selection Selects 1 of 15 signal codes The signal codes are programmed with software and are up to 5 DTMF signals

[PDF] BAOFENG Baofeng Quick Reference Guide by Rich Bugarin W6EC

Basic Operation: The VFO / MR Button toggles basic operation between VFO = Variable Frequency Operation mode (Frequency Mode) and MR = Memory mode

[PDF] Baofeng UV-5R - The (Chinese) Radio Documentation Project

Scanning To resume scanning you must press and hold the key again Tone Scanning In frequency mode you can scan for CTCSS tones and DCS codes on

[PDF] Baofeng_UV-5R Cheat_Sheetpdf - KE8OMY

18 jui 2020 · https://w7apk com/baofeng Baofeng Cheat Sheet (https://amazon com/dp/ B072HXQ5GG/?tag=w7apk-20) The Baofeng UV-5R

[PDF] UV-5RV2+ - Baofeng Radio

The UV-5R is a dual band/dual display radio made to combine extensive Allows storage of up to 105 programmable DCS codes and 50 CTCSS privacy codes

[PDF] CERT Communications - Issaquah Citizen Corps

30 mar 2017 · A Collection of Cheat Sheets Basic Radio: Baofeng UV-5R ($25-$30) or BF- F8HP ($60-$70) Programming Your Baofeng UV-5R Radio

BAOFENG UV-5R

Turn ON/OFF and Adjust volume: turn knob on top

INITIAL SET UP:

Turn off dual monitor mode: MENU-7-MENU-0-MENU-EXIT

MENU-3-6-MENU-0-MENU-EXIT

MENU-3-7-MENU-0-MENU-EXIT

MENU-3-9-MENU-0-MENU-EXIT

Change Power Level: MENU-2-MENU-0 (1 for low)-MENU-EXIT Lock Keypad: Press and hold LOCK, repeat to unlock Memory Recall (Memory mode) and VFO mode: the VFO/MR button toggles between frequency mode and memory mode.

Change Frequency:

In memory mode, use STbuttons

In VFO mode, press six number buttons

Change Band: BAND, repeat until desired band

Turn off Repeater Offset: MENU-2-5-MENU-0 (1 for + / 2 for - ) -

MENU-EXIT

Reverse Repeater Input and Output: SCAN/REV toggles, repeat to undo Note: Repeater offsets for two meters are typically negative below 147 MHz and positive for 147 MHZ and above. For 70 cm, offsets are positive below 445 MHz, and negative above 445 MHz

Program a memory channel:

(Note: You cannot overwrite a memory channel. If the channel name in the display is CH-NNN it means there is programming in place for channel NNN; if it merely says NNN, then the channel has not been programmed and you may safely enter any new receiving and transmitting frequencies, etc. See Delete a Memory Channel below)

In VFO mode (toggle VFO/MR)

Select the VFO-A mode (toggle the A/B button) Look for the S arrow in the top line in the display. Everything relies on this step !!

Select desired band: Band repeat to desired band

Enter desired frequency: six digits on number pad

Enter offset frequency: MENU-2-6-MENU-00.600 for 2M (144-158 MHz) 05.000 for 70 cm band (420-450 MHz)-

MENU-EXIT (delete this step for simplex)

Enter offset direction: MENU-2-5-MENU-0 for simplex (1 for + /2 for - )-MENU-EXIT Set CTCSS Tone: MENU-1-3-MENU-(enter tone frequency on number pad- no decimal needed) - MENU-EXIT Save receive frequency in memory: MENU-2-7-MENU-enter memory channel on number pad -MENU-EXIT Save Transmit frequency in memory:- SCAN/REV -MENU-2-

7-MENU-(enter same memory channel number on number

pad) -MENU-EXIT-SCAN/REV To access the memorized channel, remember to return to memory mode from VFO mode by once again toggling VFO/MR Delete a memory channel: MENU-2-8-MENU-(channel number to be deleted) - MENU-EXITquotesdbs_dbs14.pdfusesText_20

[PDF] [PDF] BAOFENG UV-5R - Multnomah County ARES

[PDF] UV-5R Cheat Sheettxt - Notepad