[PDF] [PDF] Configurer le routage interVLAN sur des commutateurs de - Cisco

[PDF] Configurer le routage interVLAN sur des commutateurs de - Cisco

Switch(config)#ip routing Note: Si le commutateur n'accepte pas la commande ip routing, effectuez une mise à niveau soit vers l'image SMI Cisco IOS Version 

[PDF] Configuring Layer 3 Interfaces - Cisco

The Catalyst 4500 series switch supports Layer 3 interfaces with the Cisco IOS IP and IP routing protocols Layer 3, the network layer, is primarily responsible for 

[PDF] Multilayer Switching - Router Alley

Each subinterface must support the encapsulation protocol used by the trunk port on SwitchA Configuration on SwitchA would be as follows: SwitchA(config)# 

[PDF] This chapter covers the following topics: • Multilayer Switching

Multilayer Switching Architecture on Catalyst Switches • MLS Memory Table Architecture • CEF-Based MLS Configuration, Verification, and Troubleshooting  

[PDF] Chapter 4: Implementing Inter-VLAN Routing

Layer 3 interface Switch(config-if)# no switchport ▫ Step 3 Configure the IP address and IP subnet mask This 

[PDF] Configuration Guide of Layer3 Managed Switch - PLANET Technology

User's Manual of PLANET 24-Port Gigabit Layer 3 Stackable Managed Switch with 4 10G Slots Models: SGS-6341-24T4X, SGS-6341-24P4X and SGS-6341- 

[PDF] Catalyst 6000 and 6500 Series Multilayer Switch Module Installation

Overview of the Multilayer Switch Module Internal Interfaces, on page 14 — Overview of InterVLAN Routing, on page 15 — Configuring VTP and VLANs on the 

[PDF] Catalyst 3550 Multilayer Switch Software Configuration Guide

between Cisco and any other company (0406R) Catalyst 3550 Multilayer Switch Software Configuration Guide Copyright © 2004 Cisco Systems, Inc All rights 

[PDF] Inter-VLAN Routing Configuration - FedVTE

The multilayer switch must have IP routing enabled ▫ A switch virtual interface ( SVI) exists for VLAN 1 by default On a multilayer switch, a logical (layer 

[PDF] multilevel feedback queue implementation

[PDF] multilevel feedback queue scheduling tutorialspoint

[PDF] multilevel feedback queue scheduling code in java

[PDF] multilevel feedback queue scheduling program in c++

[PDF] multilevel inverter block diagram

[PDF] multilevel inverter ppt

[PDF] multilevel inverter project report

[PDF] multilevel inverter switching pattern

[PDF] multilevel inverter thesis

[PDF] multilevel inverters syllabus

[PDF] multilevel queue scheduling

[PDF] multimedia powerpoint presentation examples

[PDF] multimedia presentation software examples

[PDF] multimedia presentations

[PDF] multinational company profile pdf

l l ip routing

Switch(config)#

ip routing ip routing show running-configuration ip routing show vlan

Switch#

vlan database

Switch(vlan)#

vlan 2

VLAN 2 added:

Name: VLAN0002

Switch(vlan)#

vlan 3

VLAN 3 added:

Name: VLAN0003

Switch(vlan)#

vlan 10

VLAN 10 added:

Name: VLAN0010

Switch(vlan)#

exit

APPLY completed.

Exiting....

Switch#

configure terminal Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)#

interface Vlan2

Switch(config-if)#

ip address 10.1.2.1 255.255.255.0

Switch(config-if)#

no shutdown

Switch(config)#

interface FastEthernet 0/1

Switch(config-if)#

no switchport

Switch(config-if)#

ip address 192.168.1.1 255.255.255.0

Switch(config-if)#

no shutdown no switchport Switch(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.2 ip default-gateway show ip route

Cat3550#

show ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area, * - candidate default, U - per-user static route, o - ODR, P - periodic downloaded static route Gateway of last resort is 192.168.1.2 to network 0.0.0.0

192.168.1.0/30 is subnetted, 1 subnets

C 192.168.1.0 is directly connected, FastEthernet0/48

10.0.0.0/24 is subnetted, 3 subnets

C 10.1.10.0

is directly connected,

Vlan10

C 10.1.3.0

is directly connected, Vlan3

C 10.1.2.0

is directly connected, Vlan2

S* 0.0.0.0/0 [1/0] via 192.168.1.2

l show ip interface brief l show ip interface brief no shutdown show ip interface brief BW 1000000 Kbit (1 gigabit), parce que la bande entrante interne du processeur de routage est seulement de 1 gigabit par conception. l l l l lquotesdbs_dbs17.pdfusesText_23