[PDF] Catalyst 6000 and 6500 Series Multilayer Switch Module Installation PDF newaries.pdf

Overview of the Multilayer Switch Module Internal Interfaces, on page 14 — Overview of InterVLAN Routing, on page 15 — Configuring VTP and VLANs on the

Switch(config)#ip routing Note: Si le commutateur n'accepte pas la commande ip routing, effectuez une mise à niveau soit vers l'image SMI Cisco IOS Version

[PDF] Configuring Layer 3 Interfaces - Cisco

The Catalyst 4500 series switch supports Layer 3 interfaces with the Cisco IOS IP and IP routing protocols Layer 3, the network layer, is primarily responsible for

[PDF] Multilayer Switching - Router Alley

Each subinterface must support the encapsulation protocol used by the trunk port on SwitchA Configuration on SwitchA would be as follows: SwitchA(config)#

[PDF] This chapter covers the following topics: • Multilayer Switching

Multilayer Switching Architecture on Catalyst Switches • MLS Memory Table Architecture • CEF-Based MLS Configuration, Verification, and Troubleshooting

[PDF] Chapter 4: Implementing Inter-VLAN Routing

Layer 3 interface Switch(config-if)# no switchport ▫ Step 3 Configure the IP address and IP subnet mask This

[PDF] Configuration Guide of Layer3 Managed Switch - PLANET Technology

User's Manual of PLANET 24-Port Gigabit Layer 3 Stackable Managed Switch with 4 10G Slots Models: SGS-6341-24T4X, SGS-6341-24P4X and SGS-6341-